Toyota Tundra (2015 year). Manual — part 1327
(b) Align the No. 1 chain's orange mark plate with the crankshaft
timing gear's timing mark, and attach the chain to the gear as
shown in the illustration.
(c) Align the No. 2 chain's yellow mark plates with the timing marks
illustration.
HINT:
The crankshaft timing gear and camshaft exhaust gear will be
installed with the No. 1 and No. 2 chains connected to the gears.
(d) Install the crankshaft timing sprocket to the crankshaft.
5. INSTALL NO. 1 CHAIN VIBRATION DAMPER RH
(a) Install the vibration damper with the 2 bolts.
Torque:
21 N·m {214 kgf·cm, 15ft·lbf}
6. INSTALL NO. 1 CHAIN TENSIONER SLIPPER RH
HINT:
If you cannot install the chain tensioner slipper due to the
1UR-FE ENGINE MECHANICAL: CAMSHAFT (for Bank 2): INST...
(a) Move the stopper plate upward to release the lock, and push the
plunger deep into the tensioner.
(c) Install the chain tensioner with the 2 bolts.
Torque:
10 N·m {102 kgf·cm, 7ft·lbf}
(d) Remove the hexagon wrench from the chain tensioner.
8. INSTALL NO. 1 CHAIN SUB-ASSEMBLY LH
9. INSTALL NO. 1 CHAIN TENSIONER SLIPPER LH
10. INSTALL NO. 1 CHAIN TENSIONER ASSEMBLY LH
11. INSTALL NO. 1 CHAIN VIBRATION DAMPER LH
12. TIGHTEN CAMSHAFT TIMING GEAR
(a) LH:
Torque:
100 N·m {1020 kgf·cm, 74ft·lbf}
1UR-FE ENGINE MECHANICAL: CAMSHAFT (for Bank 2): INST...
bolt.
Torque:
100 N·m {1020 kgf·cm, 74ft·lbf}
(b) RH:
Torque:
100 N·m {1020 kgf·cm, 74ft·lbf}
bolt.
Torque:
100 N·m {1020 kgf·cm, 74ft·lbf}
13. CHECK NO. 1 CYLINDER TO TDC / COMPRESSION
14. INSTALL TIMING CHAIN COVER SUB-ASSEMBLY
(a) Install the timing chain cover
.
15. INSPECT IGNITION TIMING
16. INSPECT ENGINE IDLE SPEED
1UR-FE ENGINE MECHANICAL: CAMSHAFT (for Bank 2): INST...
Last Modified: 9-16-2014
6.6 L
Doc ID: RM000005QCO007X
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: 1UR-FE ENGINE MECHANICAL: CYLINDER BLOCK: PRECAUTION; 2015 MY Tundra [08/2014 - ]
PRECAUTION
HINT:
Any digits beyond the 0.01 mm (1/1000 in.) place for standard, minimum and maximum values should be
used as a reference only.
When both standard and maximum or minimum values are listed for an inspection, use the standard value
as a reference only and base any judgments on the maximum and minimum values.
1UR-FE ENGINE MECHANICAL: CYLINDER BLOCK: PRECAUT...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст