Toyota Tundra (2015 year). Manual — part 1370
NOTICE:
Install the lash adjuster at the same place it was removed from.
20. INSTALL NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY
(a) Apply engine oil to the lash adjuster tips and valve stem cap ends.
(b) Install the 32 valve rocker arms as shown in the illustration.
21. INSTALL CAMSHAFT BEARING CAP RH
22. INSTALL CAMSHAFT HOUSING SUB-ASSEMBLY RH
23. INSTALL CAMSHAFT BEARING CAP LH
24. INSTALL CAMSHAFT HOUSING SUB-ASSEMBLY LH
25. INSTALL CRANKSHAFT TIMING GEAR KEY
(a) Install the timing gear key.
HINT:
The other timing gear key will be installed at a later step.
26. INSTALL NO. 2 CHAIN TENSIONER ASSEMBLY
27. INSTALL NO. 1 CHAIN SUB-ASSEMBLY RH
28. INSTALL NO. 1 CHAIN VIBRATION DAMPER RH
29. INSTALL NO. 1 CHAIN TENSIONER SLIPPER RH
30. INSTALL NO. 1 CHAIN TENSIONER ASSEMBLY RH
31. INSTALL NO. 3 CHAIN TENSIONER ASSEMBLY
32. INSTALL NO. 1 CHAIN SUB-ASSEMBLY LH
33. INSTALL NO. 1 CHAIN TENSIONER SLIPPER LH
34. INSTALL NO. 1 CHAIN TENSIONER ASSEMBLY LH
35. INSTALL NO. 1 CHAIN VIBRATION DAMPER LH
36. TIGHTEN CAMSHAFT TIMING GEAR
1UR-FE ENGINE MECHANICAL: ENGINE UNIT: REASSEMBLY; 2...
37. CHECK NO. 1 CYLINDER TO TDC / COMPRESSION
(a) Temporarily install the pulley set bolt.
(b) Rotate the crankshaft clockwise, and check that the timing marks on the crankshaft timing gear and
camshaft timing gears are as shown in the illustration.
(c) Remove the crankshaft pulley set bolt.
38. INSTALL WATER INLET PIPE
39. INSTALL TIMING CHAIN COVER SUB-ASSEMBLY
40. INSTALL WATER PUMP ASSEMBLY
41. INSTALL FRONT CRANKSHAFT OIL SEAL
1UR-FE ENGINE MECHANICAL: ENGINE UNIT: REASSEMBLY; 2...
timing chain cover edge.
SST: 09223-22010
SST: 09506-35010
NOTICE:
Keep the lip free from foreign matter.
Do not tap oil seal at an angle.
42. INSTALL CRANKSHAFT TIMING GEAR KEY
(a) Install the crankshaft timing gear key to the crankshaft.
43. INSTALL SPARK PLUG TUBE GASKET
(b) Using the removed gasket and a hammer, tap in a new gasket
until it stops.
HINT:
If the removed gasket does not fit on the new one, correct the
removed one with pliers.
44. INSTALL OIL CONTROL VALVE FILTER
(a) LH:
(1) Install the valve filter in the cylinder head cover.
(2) Install a new gasket and the cylinder head cover spacer with the 3 bolts.
Torque:
10 N·m {102 kgf·cm, 7ft·lbf}
(b) RH:
(1) Install the valve filter in the cylinder head cover.
(2) Install a new gasket and the cylinder head cover spacer with
the 3 bolts.
Torque:
10 N·m {102 kgf·cm, 7ft·lbf}
45. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY RH
1UR-FE ENGINE MECHANICAL: ENGINE UNIT: REASSEMBLY; 2...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст