Toyota Tundra (2015 year). Manual — part 263
A
Last Modified: 9-16-2014
6.6 J
Doc ID: RM000001CGO03GX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: Brake Warning Light does not Come ON; 2015
MY Tundra [08/2014 - ]
Brake Warning Light does not Come ON
WIRING DIAGRAM
Refer to Brake Warning Light Remains ON
.
INSPECTION PROCEDURE
NOTICE:
When replacing the VSC actuator assembly, perform zero point calibration
.
PROCEDURE
1.
INSPECT CAN COMMUNICATION SYSTEM
(a) Check if a CAN communication system DTC is output
.
Result
RESULT
PROCEED TO
DTC is not output
A
DTC is output
B
B
GO TO CAN COMMUNICATION SYSTEM
2.
PERFORM ACTIVE TEST USING TECHSTREAM (BRAKE WARNING LIGHT)
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Select the Active Test mode and operate the BRAKE warning light using the Techstream.
ABS/VSC/TRAC
BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: Br...
TESTER DISPLAY
TEST PART
CONTROL RANGE
DIAGNOSTIC NOTE
Brake Warning Light
Brake warning light
ON / OFF
Observe combination meter
(e) Check that the BRAKE warning light turns on and off in the combination meter using the Techstream.
OK:
The BRAKE warning light turns on and off in accordance with the Techstream operation.
NG
GO TO METER / GAUGE SYSTEM
OK
REPLACE VSC ACTUATOR ASSEMBLY
BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: Br...
Last Modified: 9-16-2014
6.6 J
Doc ID: RM000003QXV022X
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: TRAC OFF Indicator Light Remains ON; 2015
MY Tundra [08/2014 - ]
TRAC OFF Indicator Light Remains ON
DESCRIPTION
w/o Multi-information Display:
The TRAC OFF indicator light comes on when the VSC OFF switch is operated
.
w/ Multi-information Display:
TRAC OFF is displayed on the multi-information display when the VSC OFF switch is operated
.
WIRING DIAGRAM
BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: ...
INSPECTION PROCEDURE
NOTICE:
When replacing the VSC actuator assembly, perform zero point calibration
.
PROCEDURE
1.
INSPECT CAN COMMUNICATION SYSTEM
(a) Check if a CAN communication system DTC is output
.
Result
RESULT
PROCEED TO
DTC is not output
A
DTC is output
B
BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: ...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст