Toyota Tundra (2015 year). Manual — part 2180
OK
OK
(a) Check for LIN communication system DTCs related to the power window control system
.
OK:
LIN communication system DTCs are not output.
NG
GO TO LIN COMMUNICATION SYSTEM
2.
CHECK FOR DTC (B2312)
(a) Check if DTC B2312 is output
.
OK:
DTC B2312 is not output.
NG
GO TO DTC (B2312)
3.
READ VALUE USING TECHSTREAM (FRONT PASSENGER SIDE MOTOR)
(a) Use the Data List to check if the front passenger side motor is functioning properly.
P-Door Motor
TESTER
DISPLAY
MEASUREMENT ITEM/RANGE
NORMAL CONDITION
DIAGNOSTIC
NOTE
P Door P/W
Up SW
Front passenger side power window manual
UP switch signal / ON or OFF
ON: Power window regulator
switch assembly operated
OFF: Power window regulator
switch assembly not operated
-
P Door P/W
Down SW
Front passenger side power window manual
DOWN switch signal / ON or OFF
ON: Power window regulator
switch assembly operated
OFF: Power window regulator
switch assembly not operated
-
OK:
The Techstream display changes normally when power window regulator switch assembly is operated.
NG
GO TO STEP 4
OK
REPLACE FRONT POWER WINDOW REGULATOR
WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL ...
OK
MOTOR ASSEMBLY RH
4.
CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH - BODY
GROUND)
(a) Disconnect the M10 switch connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
M10-1 (GND) - Body ground
Always
Below 1 Ω
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
5.
CHECK HARNESS AND CONNECTOR (FRONT PASSENGER SIDE MOTOR - BATTERY AND
BODY GROUND)
WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL ...
OK
(a) Disconnect the M11 motor connector.
(b) Measure the voltage and resistance according to the value(s) in the table below.
Standard Voltage:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
M11-2 (B) - Body ground
Always
11 to 14 V
Standard Resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
M11-1 (GND) - Body ground
Always
Below 1 Ω
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
6.
CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH - FRONT
PASSENGER SIDE MOTOR)
WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL ...
OK
(a) Disconnect the M10 switch connector.
(b) Disconnect the M11 motor connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
M10-6 (UP) - M11-10 (UP)
Always
Below 1 Ω
M10-7 (DOWN) - M11-7 (DOWN)
Always
Below 1 Ω
M10-6 (UP) - Body ground
Always
10 kΩ or higher
M10-7 (DOWN) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
7.
INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY
WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL ...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст