Toyota Tundra (2015 year). Manual — part 2181
(a) Remove the power window regulator switch assembly
.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION
SWITCH CONDITION
SPECIFIED CONDITION
6 (UP) - 1 (GND)
Manual UP operation
Below 1 Ω
7 (DOWN) - 1 (GND)
Manual DOWN operation
Below 1 Ω
6 (UP) - 1 (GND)
Not operated
10 kΩ or higher
7 (DOWN) - 1 (GND)
Not operated
10 kΩ or higher
NG
REPLACE POWER WINDOW REGULATOR SWITCH
ASSEMBLY
OK
REPLACE FRONT POWER WINDOW REGULATOR
MOTOR ASSEMBLY RH
WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL ...
Last Modified: 9-16-2014
6.6 J
Doc ID: RM000000XI104HX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function): Rear
Power Window LH does not Operate with Rear Power Window Switch LH; 2015 MY Tundra [08/2014 - ]
Rear Power Window LH does not Operate with Rear Power Window Switch LH
DESCRIPTION
If the rear LH side manual UP/DOWN function does not operate, there may be a malfunction in the rear
switch LH, the rear motor LH, the master switch, or the harness or connector.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1.
CHECK HARNESS AND CONNECTOR (REAR SWITCH LH - BATTERY)
WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL ...
OK
(a) Disconnect the O11 switch connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
TESTER CONNECTION
SWITCH CONDITION
SPECIFIED CONDITION
O11-3 (B) - Body ground
Ignition switch ON
11 to 14 V
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
2.
INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH
(a) Remove the rear switch LH
.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL ...
OK
TESTER CONNECTION
SWITCH CONDITION
SPECIFIED CONDITION
4 (U) - 3 (B)
UP
Below 1 Ω
1 (D) - 2 (SD)
UP
Below 1 Ω
4 (U) - 5 (SU)
OFF
Below 1 Ω
1 (D) - 2 (SD)
OFF
Below 1 Ω
4 (U) - 5 (SU)
DOWN
Below 1 Ω
1 (D) - 3 (B)
DOWN
Below 1 Ω
NG
REPLACE REAR POWER WINDOW REGULATOR
SWITCH ASSEMBLY LH
3.
CHECK HARNESS AND CONNECTOR (REAR SWITCH LH - REAR MOTOR LH)
(a) Disconnect the O11 switch connector.
(b) Disconnect the O9 motor connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
O11-1 (D) - O9-1
Always
Below 1 Ω
O11-4 (U) - O9-2
Always
Below 1 Ω
WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL ...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст