Toyota Tundra (2015 year). Manual — part 2952
Last Modified: 9-16-2014
6.6 A
Doc ID: RM000002LJS04OX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY (for Double Cab): REMOVAL; 2015 MY Tundra [08/2014 -
]
REMOVAL
HINT:
Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the
battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice
before proceeding with work
.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent
airbag and seat belt pretensioner activation.
3. REMOVE FRONT SEAT ASSEMBLY
(a) for Manual Seat:
Remove the front seat
.
(b) for Power Seat:
Remove the front seat
.
4. REMOVE FRONT DOOR SCUFF PLATE
5. REMOVE REAR DOOR SCUFF PLATE
6. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP
(a) Partially remove the front door opening trim weatherstrip so that the center lower pillar garnish and center
pillar garnish can be removed
.
7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP
(a) Partially remove the rear door opening trim weatherstrip so that the center lower pillar garnish and center
pillar garnish can be removed
.
8. REMOVE LOWER CENTER PILLAR GARNISH
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY (for Double Cab...
(a) Detach the 2 claws and remove the cover.
(b) Remove the bolt and seat belt anchor.
(c) Detach the 7 clips and 2 claws, and remove the pillar garnish.
9. REMOVE CENTER PILLAR GARNISH
10. REMOVE FRONT SEAT OUTER BELT ASSEMBLY
(a) Remove the nut and shoulder anchor.
(b) Disconnect the pretensioner connector as shown in the
illustration.
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY (for Double Cab...
(c) Remove the 2 bolts and seat belt.
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY (for Double Cab...
Last Modified: 9-16-2014
6.6 G
Doc ID: RM000002LJQ038X
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY (for Double Cab): INSPECTION; 2015 MY Tundra
[08/2014 - ]
INSPECTION
1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY
CAUTION:
Do not disassemble the retractor.
(a) Before installing the seat belt, check the ELR.
operation is not as specified, replace the seat belt assembly.
(b) for Passenger's Seat only:
The check should be performed with the outer belt installed.
(1) When the belt is pulled out fully, the belt should automatically
start to retract.
(2) After the belt has fully retracted, the belt should be able to be
pulled out and retracted again.
If the operation is not as specified, replace the belt assembly.
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY (for Double Cab)...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст