Toyota Tundra (2015 year). Manual — part 2099
(b) for RH:
(1) Disconnect the M6 light connector.
(2) Disconnect the J29 relay connector.
(3) Measure the resistance according to the value(s) in the table below.
Standard resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
M6-4 (TRNR) - J29-8 (LR)
Always
Below 1 Ω
M6-3 (GND) - Body ground
M6-4 (TRNR) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN
IN PROBLEM SYMPTOMS TABLE
LIGHTING: LIGHTING SYSTEM: Turn Signal Light Circuit; 2015 M...
Last Modified: 9-16-2014
6.6 J
Doc ID: RM000002ZNJ02BX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: LIGHTING: LIGHTING SYSTEM: Hazard Warning Switch Circuit; 2015 MY Tundra [08/2014 - ]
Hazard Warning Switch Circuit
DESCRIPTION
The turn signal flasher receives a hazard warning signal switch information signal, and illuminates the turn signal
lights.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1.
INSPECT AIR CONDITIONING CONTROL ASSEMBLY
(a) Remove the air conditioning control
.
(b) Measure the resistance according to the value(s) in the table
below.
Standard resistance:
TESTER
CONNECTION
SWITCH CONDITION
SPECIFIED
CONDITION
1 - 5
Hazard warning switch
ON
Below 1 Ω
Hazard warning switch
OFF
10 kΩ or higher
LIGHTING: LIGHTING SYSTEM: Hazard Warning Switch Circuit; 20...
OK
NG
REPLACE AIR CONDITIONING CONTROL
ASSEMBLY
2.
CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL ASSEMBLY - TURN
SIGNAL FLASHER AND BODY GROUND)
(a) Disconnect the J127 switch connector.
(b) Disconnect the J29 relay connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
J127-1 - J29-12 (HAZ)
Always
Below 1 Ω
J127-1 - Body ground
J127-5 - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN
IN PROBLEM SYMPTOMS TABLE
LIGHTING: LIGHTING SYSTEM: Hazard Warning Switch Circuit; 20...
Last Modified: 9-16-2014
6.6 J
Doc ID: RM000002WKW01DX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: LIGHTING: LIGHTING SYSTEM: Taillight Circuit; 2015 MY Tundra [08/2014 - ]
Taillight Circuit
DESCRIPTION
The main body ECU receives a light control switch information signal from the headlight dimmer switch, and
illuminates the taillights.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
Inspect the bulbs for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1.
PERFORM ACTIVE TEST USING TECHSTREAM (TAILLIGHT)
(a) Operate the Techstream according to the steps on the display and select "Active Test".
Main Body
LIGHTING: LIGHTING SYSTEM: Taillight Circuit; 2015 MY Tundra [...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст