Toyota Tundra (2015 year). Manual — part 668
(a) Connect the park/neutral start switch connector, 2 transmission
wire connectors and 2 speed sensor connectors.
HINT:
(b) Connect the harness clamp with the bolt.
Torque:
8.2 N·m {84 kgf·cm, 73in·lbf}
(c) Connect the 3 connector clamps and 7 harness clamps.
(d) Tilt up the automatic transmission.
(e) Connect the ground cable with the bolt.
Torque:
5.5 N·m {56 kgf·cm, 49in·lbf}
12. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR
(a) Install the rear engine mounting insulator to the transmission with the 4 bolts.
Torque:
40 N·m {407 kgf·cm, 30ft·lbf}
13. INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
(a) Install the frame crossmember to the rear engine mounting insulator with the 4 bolts.
Torque:
21 N·m {214 kgf·cm, 15ft·lbf}
(b) Install the frame crossmember with the 4 bolts, 4 washers and 4 nuts.
Torque:
110 N·m {1122 kgf·cm, 81ft·lbf}
14. INSTALL DRIVE PLATE AND TORQUE CONVERTER CLUTCH SETTING BOLT
(a) Turn the crankshaft to gain access to the 6 bolts and install the bolts while holding the crankshaft pulley
AB60F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
set bolt with a wrench.
Torque:
53 N·m {535 kgf·cm, 39ft·lbf}
NOTICE:
First install the black colored bolt and then the remaining 5 bolts.
15. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Connect the control cable with a new clip and the nut.
Torque:
13 N·m {133 kgf·cm, 10ft·lbf}
NOTICE:
When connecting the cable to the transmission control shaft
17. INSTALL PROPELLER SHAFT ASSEMBLY
18. INSTALL FRONT PROPELLER SHAFT ASSEMBLY
19. INSTALL FRONT EXHAUST PIPE ASSEMBLY
20. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
21. ADD AUTOMATIC TRANSMISSION FLUID
22. ADD ENGINE COOLANT
23. INSPECT FOR ENGINE COOLANT LEAK
24. ADJUST SHIFT LEVER POSITION
25. INSPECT SHIFT LEVER POSITION
26. INSPECT FOR EXHAUST GAS LEAK
27. INSTALL NO. 1 ENGINE UNDER COVER
28. RESET MEMORY
AB60F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
AB60F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
Last Modified: 9-16-2014
6.6 A
Doc ID: RM000004M6X016X
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: AB60F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISSION FLUID: REPLACEMENT; 2015 MY
Tundra [08/2014 - ]
REPLACEMENT
1. REPLACE AUTOMATIC TRANSMISSION FLUID
(a) Lift the vehicle. [*1]
NOTICE:
Set the vehicle on a lift so that the vehicle is kept level when it is lifted up (make sure that the tilt angle
(c) Temporarily install the gasket and drain plug. [*3]
HINT:
Reuse the old gasket. A new gasket will be installed in step. [*15]
(d) Remove the refill plug and overflow plug. [*4]
NOTICE:
Use Toyota Genuine ATF WS.
(f) Wait until the fluid flow slows and only drops come out. [*6]
(g) Temporarily install the gasket and overflow plug. [*7]
AB60F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст