Toyota Tundra (2015 year). Manual — part 2383
INSTRUMENT PANEL: INSTRUMENT PANEL SAFETY PAD (for Floo...
Last Modified: 9-16-2014
6.6 A
Doc ID: RM000002VHU02SX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: INSTRUMENT PANEL: INSTRUMENT PANEL SAFETY PAD (for Floor Shift Type): REMOVAL; 2015 MY Tundra
[08/2014 - ]
REMOVAL
1. TABLE OF BOLT, SCREW AND NUT
HINT:
All bolts, screws and nuts relevant to installing and removing the instrument panel are shown along with
their alphabet code below.
2. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the
battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice
before proceeding with work
.
INSTRUMENT PANEL: INSTRUMENT PANEL SAFETY PAD (for Floo...
3. DISABLE AUTOAWAY/RETURN FUNCTION (for Power Tilt and Power Telescopic
Steering Column)
(a) Disable the Autoaway/Return function by changing the customize parameter
.
NOTICE:
Record the above operation causes the Autoaway/Return function to be disabled when the ignition switch is
turned off.
(b) Turn the ignition switch to ON. Operate the tilt and telescopic switch to fully extend and lower the steering
column.
(c) Turn the ignition switch off.
4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
(a) Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the
SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
5. REMOVE NO. 1 INSTRUMENT PANEL REGISTER SUB-ASSEMBLY
6. REMOVE INSTRUMENT SIDE PANEL LH
7. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
(a) Twist the shift lever knob sub-assembly in the direction indicated
by the arrow and remove it.
8. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY
(a) Move the shift lever to N.
INSTRUMENT PANEL: INSTRUMENT PANEL SAFETY PAD (for Floo...
(b) Apply protective tape as shown in the illustration.
Text in Illustration
*1
Protective Tape
(c) Using a moulding remover B, detach the 6 clips and remove the upper rear console panel sub-assembly.
9. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
(a) Detach the 12 clips and remove the upper console panel
sub-assembly.
10. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY
(a) Using a moulding remover B, detach the 7 clips and remove the
rear console end panel sub-assembly.
(b) w/ Power Outlet Socket:
Detach the 2 wire harness clamps and disconnect the connector.
INSTRUMENT PANEL: INSTRUMENT PANEL SAFETY PAD (for Floo...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст