Toyota Tundra (2015 year). Manual — part 1343
Last Modified: 9-16-2014
6.6 K
Doc ID: RM000002S5103GX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: 1UR-FE ENGINE MECHANICAL: CYLINDER HEAD GASKET (for Bank 1): COMPONENTS; 2015 MY Tundra
[08/2014 - ]
COMPONENTS
ILLUSTRATION
1UR-FE ENGINE MECHANICAL: CYLINDER HEAD GASKET (for...
Last Modified: 9-16-2014
6.6 A
Doc ID: RM000002S5203TX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: 1UR-FE ENGINE MECHANICAL: CYLINDER HEAD GASKET (for Bank 1): REMOVAL; 2015 MY Tundra
[08/2014 - ]
REMOVAL
1. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH
(a) Remove the exhaust manifold LH
.
2. REMOVE CAMSHAFTS (for Bank 1)
(a) Remove the camshafts
.
3. REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY
(a) Remove the 16 valve rocker arms from the cylinder head.
HINT:
Arrange the removed parts in the correct order.
4. REMOVE VALVE LASH ADJUSTER ASSEMBLY
(a) Remove the 16 valve lash adjusters from the cylinder head.
HINT:
Arrange the removed parts in the correct order.
5. REMOVE VALVE STEM CAP
(a) Remove the 16 valve stem caps from the cylinder head.
HINT:
Arrange the removed parts in the correct order.
6. REMOVE CYLINDER HEAD SUB-ASSEMBLY LH
(a) Uniformly loosen and remove the 2 bolts in the sequence shown
in the illustration.
1UR-FE ENGINE MECHANICAL: CYLINDER HEAD GASKET (for...
(b) Using a 10 mm bi-hexagon wrench, uniformly loosen the 10
cylinder head bolts in the sequence shown in the illustration.
Remove the 10 cylinder head bolts and plate washers.
HINT:
Be sure to arrange the removed parts for each installation
position separately.
NOTICE:
Be careful not to drop washers into the cylinder head.
Head warpage or cracking could result from removing bolts in an
incorrect order.
7. REMOVE CYLINDER HEAD GASKET LH
1UR-FE ENGINE MECHANICAL: CYLINDER HEAD GASKET (for...
Last Modified: 9-16-2014
6.6 A
Doc ID: RM000002S5003UX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: 1UR-FE ENGINE MECHANICAL: CYLINDER HEAD GASKET (for Bank 1): INSTALLATION; 2015 MY Tundra
[08/2014 - ]
INSTALLATION
HINT:
Perform "Inspection After Repairs" after replacing the cylinder head sub-assembly LH
.
1. INSPECT CYLINDER HEAD SET BOLT
2. INSPECT CYLINDER HEAD SUB-ASSEMBLY LH
3. INSTALL CYLINDER HEAD GASKET LH
(a) Check the piston protrusions for each cylinder.
(1) Clean the cylinder block with solvent.
HINT:
Perform "Inspection After Repairs" after replacing the cylinder head sub-assembly LH
.
(a) Place the cylinder head on the cylinder block.
NOTICE:
The cylinder head bolts are tightened in 3 progressive steps.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст