Toyota Tundra (2015 year). Manual — part 1361
(1) Disconnect the 2 camshaft timing control valve connectors.
(2) Disconnect the 4 ignition coil connectors.
(3) Disconnect the 2 VVT sensor connectors.
(4) Disconnect the fuel injector connector.
(5) Disconnect the noise filter connector.
(6) Disconnect the air switching valve connector.
(7) Disconnect the oil pressure sender gauge connector.
(8) Disconnect the 6 clamps.
(c) Engine Rear Side:
(1) Disconnect the connector and clamp.
(2) Remove the 4 bolts.
(d) Remove the engine wire.
2. REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY
(a) Remove the No. 1 fuel pipe
.
3. REMOVE NO. 2 FUEL TUBE SUB-ASSEMBLY
1UR-FE ENGINE MECHANICAL: ENGINE UNIT: REMOVAL; 201...
(a) Remove the No. 2 fuel tube
.
4. REMOVE AIR SWITCHING VALVE ASSEMBLY (for Bank 1)
(a) Remove the 2 bolts.
(b) Remove the 3 bolts, air switching valve assembly and gasket.
NOTICE:
(a) Remove the 2 bolts.
(b) Remove the 3 bolts, air switching valve assembly and gasket.
NOTICE:
1UR-FE ENGINE MECHANICAL: ENGINE UNIT: REMOVAL; 201...
(a) Remove the bolt and wire harness clamp bracket.
(b) Remove the bolt and No. 4 air tube.
7. REMOVE NO. 3 AIR TUBE
(a) Remove the bolt and wire harness clamp bracket.
(b) Remove the bolt and No. 3 air tube.
8. REMOVE NO. 3 WATER BY-PASS PIPE SUB-ASSEMBLY
1UR-FE ENGINE MECHANICAL: ENGINE UNIT: REMOVAL; 201...
(a) Disconnect the hose and remove the 2 bolts and No. 3 water
by-pass pipe.
9. REMOVE NO. 8 WATER BY-PASS HOSE
(a) Remove the No. 8 water by-pass hose.
10. DISCONNECT NO. 11 WATER BY-PASS HOSE
11. REMOVE EGR COOLER ASSEMBLY
12. REMOVE CYLINDER BLOCK WATER DRAIN COCK
SUB-ASSEMBLY
(a) Remove the 2 water drain cock plugs from the water drain
cocks.
(b) Remove the 2 water drain cocks from the cylinder block.
13. REMOVE FRONT ENGINE MOUNTING INSULATOR RH
(a) Remove the nut and mounting insulator.
1UR-FE ENGINE MECHANICAL: ENGINE UNIT: REMOVAL; 201...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст