Toyota Tundra (2015 year). Manual — part 1805
Last Modified: 9-16-2014
6.6 A
Doc ID: RM000002MDO036X
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: 3UR-FBE STARTING: STARTER: DISASSEMBLY; 2015 MY Tundra [08/2014 - ]
DISASSEMBLY
1. REMOVE MAGNET STARTER SWITCH ASSEMBLY
(a) Remove the nut and disconnect the lead wire from the
magnet starter switch.
(b) Remove the 2 nuts from the starter drive housing while
holding the magnet starter switch.
(c) Pull the magnet starter switch and while lifting the front part
2. REMOVE STARTER YOKE ASSEMBLY
(a) Using a T25 "TORX" socket wrench, remove the 2 bolts.
(b) Pull out the starter yoke together with the starter commutator end frame.
3UR-FBE STARTING: STARTER: DISASSEMBLY; 2015 MY Tundra ...
(c) Remove the 2 screws and starter commutator end frame
from the starter yoke.
NOTICE:
While holding down the lead wire, remove the starter
commutator end frame.
3. REMOVE STARTER BRUSH HOLDER ASSEMBLY
so that they are held in place by the springs.
(b) Remove the starter brush holder.
4. REMOVE STARTER ARMATURE ASSEMBLY
(a) Remove the starter armature from the starter yoke.
5. REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY
(a) Remove the starter armature plate from the starter center
bearing clutch or starter yoke.
3UR-FBE STARTING: STARTER: DISASSEMBLY; 2015 MY Tundra ...
(b) Remove the 3 planetary gears from the starter center
bearing clutch.
(c) Remove the starter center bearing clutch together with the
starter pinion drive lever and rubber seal from the starter
drive housing.
(d) Remove the starter pinion drive lever and rubber seal from the starter center bearing clutch.
3UR-FBE STARTING: STARTER: DISASSEMBLY; 2015 MY Tundra ...
Last Modified: 9-16-2014
6.6 G
Doc ID: RM000002MDL03IX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: 3UR-FBE STARTING: STARTER: INSPECTION; 2015 MY Tundra [08/2014 - ]
INSPECTION
1. INSPECT STARTER ASSEMBLY
CAUTION:
As a large electric current passes through the cable during this inspection, a thick cable must be used.
Otherwise, the cable may become hot and cause injury.
NOTICE:
These tests must be performed within 3 to 5 seconds to avoid burning out the coil.
(a) Perform a pull-in test.
(1) Remove the nut, and then disconnect the field coil lead wire from terminal C.
(2) Connect the battery to the magnet starter switch as
shown in the illustration. Then check that the clutch pinion
gear moves outward.
If the clutch pinion gear does not move outward, replace
the magnet starter switch assembly.
(b) Perform a holding test.
(1) When the battery is connected as above with the clutch
pinion gear out, disconnect the negative (-) lead from
terminal C. Check that the pinion gear remains out.
If the clutch pinion gear moves inward, replace the
magnet starter switch assembly.
(c) Inspect the clutch pinion gear return.
3UR-FBE STARTING: STARTER: INSPECTION; 2015 MY Tundra [0...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст