Toyota FJ Cruiser (GSJ 10, 15 series). Instruction — part 301
LI–98
LIGHTING – REAR ROOM LIGHT ASSEMBLY
LI
BODY ELECTRICAL
LIGHTING
REAR ROOM LIGHT ASSEMBLY
COMPONENTS
REAR ROOM LIGHT
ASSEMBLY
ROOM LIGHT SWITCH BASE
ROOM LIGHT BULB NO. 1
ROOM LIGHT HOUSING
ASSEMBLY
ROOM LIGHT COVER
ROOM LIGHT LENS
ROOM LIGHT
COVER
E127222E01
LIGHTING – REAR ROOM LIGHT ASSEMBLY
LI–99
LI
REMOVAL
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
2.
REMOVE REAR ROOM LIGHT ASSEMBLY
(a) Using a screwdriver with its tip wrapped in
protective tape, disengage the 4 claws and remove
the room light lens.
(b) Using a screwdriver with its tip wrapped in
protective tape, disengage the 4 claws and remove
the 2 covers.
(c) Using a screwdriver with its tip wrapped in
protective tape, disengage the 4 claws.
Protective
Tape
E114441E01
Protective Tape
B124365E01
Protective
Tape
E114442E01
LI–100
LIGHTING – REAR ROOM LIGHT ASSEMBLY
LI
(d) Disengage the roof wire from the claw of the room
light.
(e) Using a screwdriver with its tip wrapped in
protective tape, disengage the 4 claws and remove
the room light switch base.
(f)
Remove room light bulb No. 1.
INSPECTION
1.
INSPECT REAR ROOM LIGHT ASSEMBLY
(a) Check the resistance.
(1) Using an ohmmeter, measure the resistance
and check the results in accordance with the
value(s) in the table below.
Standard Resistance
If the result is not as specified, replace the
room light.
(b) Check the light operation.
(1) Connect the positive (+) battery lead to terminal
B and the negative (-) battery lead to terminal
CTY, then check that the light illuminates when
the switch is in the DOOR position.
Standard:
Light illuminates.
If the light does not illuminate, replace the bulb.
(2) Connect the positive (+) battery lead to terminal
B and the negative (-) battery lead to terminal
E, then check that the light illuminates when
the switch is in the ON position.
Standard:
Light illuminates.
If the light does not illuminate, replace the bulb.
Protective Tape
B138412E01
DOOR
OFF
ON
E
CTY
B
E114448E01
Tester Connection
Condition
Specified Condition
-
OFF
10 k
Ω or higher
CTY - B
DOOR
Below 1
Ω
B - E
ON
Below 1
Ω
LIGHTING – REAR ROOM LIGHT ASSEMBLY
LI–101
LI
INSTALLATION
1.
INSTALL REAR ROOM LIGHT ASSEMBLY
(a) Install room light bulb No. 1.
(b) Engage the 4 claws and install the room light switch
base.
(c) Install the roof wire into the claw of the room light.
(d) Engage the 4 claws and install the room light.
(e) Engage the 4 claws and install the 2 covers.
B138415
E114445
B124366
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст