Toyota FJ Cruiser (GSJ 10, 15 series). Instruction — part 300
LIGHTING – ROOM LIGHT ASSEMBLY
LI–95
LI
REMOVAL
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
2.
REMOVE ROOM LIGHT ASSEMBLY
(a) Using a screwdriver with its tip wrapped in
protective tape, disengage the 4 claws and remove
the room light lens.
(b) Using a screwdriver with its tip wrapped in
protective tape, disengage the 4 claws and remove
the 2 covers.
(c) Using a screwdriver with its tip wrapped in
protective tape, disengage the 4 claws.
Protective
Tape
E114441E01
Protective Tape
B124365E01
Protective
Tape
E114442E01
LI–96
LIGHTING – ROOM LIGHT ASSEMBLY
LI
(d) Disengage the roof wire from the claw of the room
light.
(e) Using a screwdriver with its tip wrapped in
protective tape, disengage the 4 claws and remove
the room light switch base.
(f)
Remove room light bulb No. 1.
INSPECTION
1.
INSPECT ROOM LIGHT ASSEMBLY
(a) Check the resistance.
(1) Using an ohmmeter, measure the resistance
and check the results in accordance with the
value(s) in the table below.
Standard Resistance
If the result is not as specified, replace the
room light.
(b) Check the light operation.
(1) Connect the positive (+) battery lead to terminal
B and the negative (-) battery lead to terminal
CTY, then check that the light illuminates when
the switch is in the DOOR position.
Standard:
Light illuminates.
If the light does not illuminate, replace the bulb.
(2) Connect the positive (+) battery lead to terminal
B and the negative (-) battery lead to terminal
E, then check that the light illuminates when
the switch is in the ON position.
Standard:
Light illuminates.
If the light does not illuminate, replace the bulb.
Protective Tape
B138413E01
DOOR
OFF
ON
E
CTY
B
E114448E01
Tester Connection
Condition
Specified Condition
-
OFF
10 k
Ω or higher
CTY - B
DOOR
Below 1
Ω
B - E
ON
Below 1
Ω
LIGHTING – ROOM LIGHT ASSEMBLY
LI–97
LI
INSTALLATION
1.
INSTALL ROOM LIGHT ASSEMBLY
(a) Install room light bulb No. 1.
(b) Engage the 4 claws and install the room light switch
base.
(c) Install the roof wire into the claw of the room light.
(d) Engage the 4 claws and install the room light.
(e) Engage the 4 claws and install the 2 covers.
B138414
E114445
B124366
LI–98
LIGHTING – ROOM LIGHT ASSEMBLY
LI
(f)
Engage the 4 claws and install the room light lens.
2.
CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
E114446
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст