Toyota FJ Cruiser (GSJ 10, 15 series). Instruction — part 461
SE–26
SEAT – FRONT SEAT ASSEMBLY
SE
(g) for Front Passenger Side:
(1) Connect the connector.
(2) w/ Front Seat Side Airbag:
1. Connect the airbag connector.
(3) Install the clamp.
2.
INSTALL FRONT SEAT TRACK COVER
HINT:
Use the same procedure for both sides.
(a) Insert the front seat track cover 2 guides in between
the seat rail and the seat leg. Then slightly lift up the
front seat track cover rear part and carefully push
the front seat track cover in until it cannot be pushed
in any further.
(b) Carefully insert the front seat track cover outside
claw into the seat leg corner groove according to the
procedure shown in the illustration.
(c) Carefully push directly from the top of the front seat
track cover inside claw to insert it into the seat leg
corner groove, as shown in the illustration.
3.
CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
4.
INSPECT SRS WARNING LIGHT (w/ Front Seat Side
Airbag)
(See page
)
B135120
Guide
1
2
B138598E01
1
2
3
4
B138599E01
SE–26
SEAT – REAR SEAT ASSEMBLY (for LH Side)
SE
BODY
SEAT
REAR SEAT ASSEMBLY (for LH Side)
COMPONENTS
REAR SEAT CUSHION
ASSEMBLY
REAR SEATBACK
ASSEMBLY
REAR SEATBACK BOARD
CARPET ASSEMBLY
REAR CENTER SEAT
INNER BELT ASSEMBLY
37 (375, 27)
N*m (kgf*cm, ft*lbf) : Specified torque
37 (375, 27)
37 (375, 27)
x2
B130717E01
SEAT – REAR SEAT ASSEMBLY (for LH Side)
SE–27
SE
REAR SEAT
CUSHION COVER
REAR SEAT CUSHION
FRAME SUB-ASSEMBLY
REAR SEAT CUSHION
HINGE SUB-ASSEMBLY
REAR SEAT CUSHION
STOPPER
REAR SEAT CUSHION
UNDER COVER
REAR SEAT CUSHION
HINGE SUB-ASSEMBLY
18 (185, 13)
N*m (kgf*cm, ft*lbf) : Specified torque
Non-reusable part
REAR SEAT
CUSHION PAD
x10
x5
18 (185, 13)
B130722E01
SE–28
SEAT – REAR SEAT ASSEMBLY (for LH Side)
SE
REAR SEAT HEADREST
ASSEMBLY
REAR SEAT HEADREST
SUPPORT
REAR SEATBACK FRAME
SUB-ASSEMBLY
REAR SEATBACK
LOCK ASSEMBLY
REAR SEATBACK
LOCK COVER
REAR SEATBACK LOCK
RELEASE BUTTON
REAR SEATBACK STOP
BUTTON GROMMET
REAR SEATBACK PAD
N*m (kgf*cm, ft*lbf) : Specified torque
Non-reusable part
18 (185, 13)
x2
x22
TETHER ANCHOR
COVER
REAR SEATBACK COVER
B130729E01
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст