Toyota FJ Cruiser (GSJ 10, 15 series). Instruction — part 200
EXTERIOR – NAME PLATE
ET–31
ET
3.
INSTALL NO. 1 BACK DOOR NAME PLATE
(a) Clean the attachment surface.
(1) Using an infrared light, heat the double-sided
adhesive tape remaining on the back door
panel.
HINT:
Heat at 40 to 60
°C (104 to 140°F) for 1 to 2
minutes.
(2) Using a shop rag or piece of cloth, rub the
remaining double-sided adhesive tape off the
back door panel while it is hot from the infrared
light.
NOTICE:
Installing the No. 1 back door name plate
while any double-sided adhesive tape
remains on the back door panel may cause
adhesion failure. Therefore, completely
remove the double-sided adhesive tape.
(3) Using a non-residue solvent, clean the
attachment surface.
(b) Install a new No. 1 back door name plate as shown
in the illustration.
Installation position
NOTICE:
Install the No. 1 back door name plate in an
environment where the ambient temperature is
over 20
°C (68°F). If it is below 20°C (68°F), using
an infrared light, heat the back door panel and
the No. 1 back door name plate up to 20 to 30
°C
(68 to 86
°F) and install the No. 1 back door name
plate.
Peeling Paper
Back Door Panel
Relief R End Line
a
b
B134742E01
Mark
Measurement (along surface)
a
28.4 mm (1.118 in.)
b
11.5 mm (0.453 in.)
ET–32
EXTERIOR – REAR SPOILER
ET
BODY
EXTERIOR
REAR SPOILER
COMPONENTS
REAR SPOILER
REAR SPOILER COVER
x4
x4
N*m (kgf*cm, ft*lbf) : Specified torque
3.0 (30, 27 in.*lbf)
NO. 2 BACK DOOR
WIRE
B135159E01
EXTERIOR – REAR SPOILER
ET–33
ET
HIGH MOUNTED STOP
LIGHT ASSEMBLY
REAR WASHER
NOZZLE
w/ Rear Wiper:
x2
B135160E01
ET–34
EXTERIOR – REAR SPOILER
ET
REMOVAL
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
2.
REMOVE REAR SPOILER COVER
(a) Remove the 4 screws and the rear spoiler cover.
3.
REMOVE REAR SPOILER
(a) Disconnect high mounted stop light connector.
(b) Using a clip remover, remove the 3 clamps.
(c) Remove the washer hose from the claw of the rear
spoiler.
(d) Disconnect the washer hose.
(e) Remove the 4 nuts.
DISASSEMBLY
1.
REMOVE REAR WASHER NOZZLE (w/ Rear Wiper)
(a) Disengage the 2 claws and remove the rear washer
nozzle.
B135161
B135162
B135163
B135164
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст