Toyota FJ Cruiser (GSJ 10, 15 series). Instruction — part 303
LIGHTING – HEADLIGHT DIMMER SWITCH
LI–105
LI
(c) Check the resistance of the turn signal switch.
(1) Using an ohmmeter, measure the resistance
and check the results in accordance with the
value(s) in the table below.
Standard Resistance
If the result is not as specified, replace the
headlight dimmer switch.
INSTALLATION
1.
INSTALL HEADLIGHT DIMMER SWITCH
(a) Install the headlight dimmer switch with the 2
screws.
(b) Connect the connector.
2.
INSTALL STEERING COLUMN COVER
(a) Engage the claw and install the upper steering
column cover.
(b) Engage the 2 claws and install the lower steering
column cover.
Tester Connection
Condition
Specified Condition
2 - 3
Right turn
Below 1
Ω
2 - 3
Neutral
10 k
Ω or higher
1 - 2
Neutral
10 k
Ω or higher
1 - 2
Left turn
Below 1
Ω
E127237
E127253
E127235
LI–106
LIGHTING – HEADLIGHT DIMMER SWITCH
LI
(c) Turn the steering wheel to the right and tighten the
screw indicated in the illustration.
(d) Turn the steering wheel to the left and tighten the
screw indicated in the illustration.
(e) Tighten the screw indicated in the illustration.
3.
CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
E127232
E127231
E127233
LIGHTING – HAZARD WARNING SWITCH
LI–107
LI
BODY ELECTRICAL
LIGHTING
HAZARD WARNING SWITCH
COMPONENTS
INSTRUMENT PANEL
GARNISH LH
INSTRUMENT PANEL
GARNISH RH
INTEGRATION CONTROL
AND PANEL ASSEMBLY
x2
E127251E01
LI–108
LIGHTING – HAZARD WARNING SWITCH
LI
REMOVAL
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
2.
REMOVE INSTRUMENT PANEL GARNISH LH (See
page
3.
REMOVE INSTRUMENT PANEL GARNISH RH (See
page
4.
REMOVE INTEGRATION CONTROL AND PANEL
ASSEMBLY
(a) Remove the 2 screws.
(b) Disengage the 4 clips and remove the integration
control and panel.
INSPECTION
1.
INSPECT INTEGRATION CONTROL AND PANEL
ASSEMBLY
(a) Check the resistance of the hazard warning switch.
(1) Using an ohmmeter, measure the resistance
and check the results in accordance with the
value(s) in the table below.
Standard Resistance
If the result is not as specified, replace the
integration control and panel.
B133888
Ohmmeter
E127252E01
Tester Connection
Condition
Specified Condition
19 - 20
ON
Below 3
Ω
19 - 20
OFF
10 M
Ω or higher
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст