Toyota FJ Cruiser (GSJ 10, 15 series). Instruction — part 353
PM–34
PARK ASSIST / MONITORING – CLEARANCE WARNING BUZZER
PM
BODY ELECTRICAL
PARK ASSIST / MONITORING
CLEARANCE WARNING BUZZER
COMPONENTS
CLEARANCE WARNING
BUZZER
CLEARANCE WARNING
BUZZER CONNECTOR
B135079E01
PARK ASSIST / MONITORING – CLEARANCE WARNING BUZZER
PM–35
PM
REMOVAL
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
2.
REMOVE CLEARANCE WARNING BUZZER
(a) Disconnect the clearance warning buzzer
connector.
(b) Disengage the clamp and remove the clearance
warning buzzer.
INSPECTION
1.
INSPECT CLEARANCE WARNING BUZZER
(a) Check the resistance.
(1) Using an ohmmeter, measure the resistance
between the terminals.
Standard resistance
If the result is not as specified, replace the
clearance warning buzzer.
B135080
Ohmmeter
B138426E01
Tester Connection
Specified Condition
1 - 2
Approximately 1 k
Ω
PM–36
PARK ASSIST / MONITORING – CLEARANCE WARNING BUZZER
PM
INSTALLATION
1.
INSTALL CLEARANCE WARNING BUZZER
(a) Engage the clamp and install the clearance warning
buzzer.
(b) Connect the clearance warning buzzer connector.
2.
CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
B135080
PARK ASSIST / MONITORING – ULTRASONIC SENSOR
PM–37
PM
BODY ELECTRICAL
PARK ASSIST / MONITORING
ULTRASONIC SENSOR
COMPONENTS
REAR BUMPER
COVER
ULTRASONIC SENSOR
N*m (kgf*cm, ft*lbf) : Specified torque
3.0 (30, 27 in.*lbf)
x2
3.0 (30, 27 in.*lbf)
x2
8.0 (80, 71 in.*lbf)
x5
WIRE to WIRE
CONNECTOR
ULTRASONIC SENSOR
CONNECTOR
WIRE to WIRE
CONNECTOR
B138491E01
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст