Toyota FJ Cruiser (GSJ 10, 15 series). Instruction — part 354
PM–38
PARK ASSIST / MONITORING – ULTRASONIC SENSOR
PM
REMOVAL
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
2.
REMOVE REAR BUMPER COVER (See page
)
3.
REMOVE ULTRASONIC SENSOR
(a) Disconnect the ultrasonic sensor connector.
(b) Remove the retainer and the ultrasonic sensor as
shown in the illustration.
INSPECTION
1.
INSPECT ULTRASONIC SENSOR
(a) Check the resistance.
(1) Using an ohmmeter, measure the resistance
between the terminals.
Standard resistance
If the result is not as specified, replace the
ultrasonic sensor.
B138492
Ohmmeter
B138494E01
Tester Connection
Specified Condition
1 (E) - 2 (S)
8 to 12 k
Ω
PARK ASSIST / MONITORING – ULTRASONIC SENSOR
PM–39
PM
INSTALLATION
HINT:
The procedure described below is for the LH side. Use the
same procedure for both the RH and LH sides, unless
otherwise specified.
1.
INSTALL ULTRASONIC SENSOR
(a) Install the ultrasonic sensor with the retainer as
shown in the illustration.
(b) Connect the ultrasonic sensor connector.
2.
INSTALL REAR BUMPER COVER (See page
3.
CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
B138493
PM–40
PARK ASSIST / MONITORING – BACK SONAR SWITCH ASSEMBLY
PM
BODY ELECTRICAL
PARK ASSIST / MONITORING
BACK SONAR SWITCH ASSEMBLY
COMPONENTS
FRONT CONSOLE BOX
FRONT CONSOLE BOX
BOTTOM MAT
FRONT CONSOLE BOX UPPER
PANEL SUB-ASSEMBLY
PARKING BRAKE HOLE
COVER SUB-ASSEMBLY
SHIFT LEVER KNOB
SUB-ASSEMBLY
SHIFT LEVER KNOB
SUB-ASSEMBLY
x4
SHIFT LEVER KNOB
SUB-ASSEMBLY
for Manual Transmission:
for Automatic Transmission 4WD:
B135184E01
PARK ASSIST / MONITORING – BACK SONAR SWITCH ASSEMBLY
PM–41
PM
BACK SONAR
SWITCH ASSEMBLY
BACK SONAR
SWITCH BULB
BACK SONAR
SWITCH BULB CAP
INSTRUMENT LOWER
COVER SUB-ASSEMBLY
CLIP
x2
x2
INSTRUMENT PANEL
WIRE
B138461E01
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст