Audi TT (2007 year). Manual — part 6
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Detach electrical connector -1- from bracket and unplug.
– Move clear electrical wiring.
Note
Disregard -items 2, 3 and 4-.
– Slacken bolt -2- and remove clamp.
Note
Disregard -items 1, 3-.
– Unplug electrical connector -2- on exhaust gas pressure sen‐
sor 1 -G450- .
– Remove bolt -1-.
Note
Disregard -arrows-.
1. Removing engine
15
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unplug electrical connector -4- on fuel temperature sender -
G81- .
WARNING
The fuel can become extremely hot. This can cause injuries.
♦ In extreme cases the temperature of the fuel lines and the
fuel can be up to 100 °C after the engine is switched off.
Allow the fuel to cool down before disconnecting the lines
- danger of scalding.
♦ Wear protective gloves.
♦ Wear safety goggles.
– Release hose clips -2- and -3- and disconnect fuel supply hose
and fuel return hose.
Note
Disregard items marked -1- and -arrow-.
– Release hose clip -1- and detach coolant hose.
Note
Ignore items marked -2- and -arrows-.
– Disengage fuel hose -3- at bracket.
– Pull off bracket for fuel lines towards right -arrow- and move
clear to one side.
– Unplug electrical connector -1- at supplementary fuel pump -
V393- .
– Remove bolts -2- and -4-, detach bracket with supplementary
fuel pump -V393- and move clear to one side.
16
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Release hose clip -1-, detach coolant hose from coolant ex‐
pansion tank and move coolant hose clear -arrow-.
– Lift retaining clip -arrow- and disconnect coolant hose (top left)
from radiator.
– Unplug electrical connector -A- at high-pressure sender -G65-
-item B-.
Note
Disregard -item C-.
– Remove bolts -top arrows- at rear and lift out radiator.
1. Removing engine
17
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Pry off caps on windscreen wiper arms with a screwdriver.
– Slacken nuts -arrows- one turn.
– Apply puller -T10369/1- to wiper arm -1- as shown in illustra‐
tion.
– Apply thrust piece -2- onto wiper shaft.
– Turn bolt -3- in clockwise direction until wiper arm is pulled off
wiper shaft.
– Remove nuts and detach windscreen wiper arms.
– Remove seal -1-.
Caution
Risk of damage to plenum chamber cover.
♦ Apply a small quantity of soap solution to transition be‐
tween windscreen and plenum chamber cover -2-. Then,
starting at edge of windscreen, carefully pull plenum
chamber cover upwards off retainer at windscreen
-arrows-.
– Detach plenum chamber cover by pulling it carefully off re‐
tainer at windscreen.
– Move clear engine wiring harness at rear of plenum chamber
partition panel.
-arrow- and detach.
18
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст