Ford Galaxy / Ford S-MAX. Manual — part 999
ramps for
deformation.
2. Torque: 6 Nm
3.
NOTE: Make
sure that
these
components
are installed
to the noted
removal
position.
Attach the side
air bag module
retaining clips in
the following
sequence.
4.
NOTE: Make sure that these components are installed
to the noted removal position.
Attach the side air bag module retaining clips in the
following sequence.
5. This step is only required when installing the left-hand side
air curtain.
6. This step is only required when installing the right-hand
side air curtain.
7.
NOTE: Make sure that this component is installed to
the noted removal position.
8. Torque: 10 Nm
9. Remove the protective strap from all of the side air bag
module retaining clips.
10. Install the headliner.
11. Initialize the door window motors.
Refer to:
Door Window Motor Initialization
(501-11 Glass,
Frames and Mechanisms, General Procedures).
Supplemental Restraint System -
Restraints Control Module (RCM)
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
General Equipment
Removal
WARNINGS:
The supplemental restraint system (SRS) is active for a certain length of time after
the power supply has been disconnected. Wait for a minimum of 3 minutes before
disconnecting or removing any SRS components.
Make sure that the vehicle electrical system is fully depowered and no other power
source is connected.
Wear safety goggles.
Refer to:
Supplemental Restraint System (SRS) Health and Safety Precautions
(100-
00 General Information, Description and Operation).
Ford diagnostic equipment
1. Disconnect the battery ground cable.
Refer to:
Battery Disconnect and Connect
(414-
01 Battery, Mounting and Cables, General
Procedures).
2. Remove the floor console.
Refer to:
Floor Console - VIN Plate Body Style
Code: M
(501-12 Instrument Panel and Console,
Removal and Installation).
Refer to:
Floor Console - Vehicles With:
Electronic Parking Brake (EPB), VIN Plate Body
Style Code: M
(501-12 Instrument Panel and
Console, Removal and Installation).
Refer to:
Floor Console - VIN Plate Body Style
Code: S
(501-12 Instrument Panel and Console,
Removal and Installation).
Refer to:
Floor Console - Vehicles With:
Electronic Parking Brake (EPB), VIN Plate Body
Style Code: S
(501-12 Instrument Panel and
Console, Removal and Installation).
Refer to:
Floor Console Upper Section - Vehicles
With: Center Armrest/Manually Adjusted Parking
Brake
(501-12 Instrument Panel and Console,
Removal and Installation).
Refer to:
Floor Console Upper Section - Vehicles
With: Manually Adjusted Parking Brake, Vehicles
Without: Center Armrest
(501-12 Instrument
Panel and Console, Removal and Installation).
3. If equipped.
Installation
4.
1. Torque: 8 Nm
2. To install, reverse the removal procedure.
3. When a new RCM is installed, configure the RCM
using the diagnostic tool.
General Equipment:
Ford diagnostic equipment
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст