Ford Galaxy / Ford S-MAX. Manual — part 1000
Supplemental Restraint System -
Passenger Air Bag Deactivation (PAD)
Switch
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Removal
WARNINGS:
The supplemental restraint system (SRS) is active for a certain length of time after
the power supply has been disconnected. Wait for a minimum of 3 minutes before
disconnecting or removing any SRS components.
Make sure that the vehicle electrical system is fully depowered and no other power
source is connected.
Wear safety goggles.
Refer to:
Supplemental Restraint System (SRS) Health and Safety Precautions
(100-
00 General Information, Description and Operation).
NOTE: Removal steps in this procedure may contain installation details.
Vehicles with air conditioning
1. Disconnect the battery ground cable.
Refer to:
Battery Disconnect and Connect
(414-
01 Battery, Mounting and Cables, General
Procedures).
2. Remove the navigation system digital versatile
disc (DVD) unit, if equipped.
Refer to: Navigation System Digital Versatile Disc
(DVD) Unit (415-01 Information and
Entertainment System, Removal and
Installation).
3.
4.
5.
All vehicles
Installation
6.
7.
1. To install, reverse the removal procedure.
2. Initialize the door window motors.
Refer to: Door Window Motor Initialization (501-
11 Glass, Frames and Mechanisms, General
Procedures).
Supplemental Restraint System -
Clockspring
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Removal
Installation
1. Refer to:
Steering Wheel
(211-04 Steering
Column, Removal and Installation).
2.
3.
4.
1.
CAUTION: Make sure that the
clockspring rotor does not rotate.
NOTE: This step is not necessary when
installing a new component.
Secure the clockspring rotor with adhesive
tape to the clockspring outer.
5.
CAUTIONS:
Make sure that the clockspring pins are
not bent or damaged.
Make sure that the clockspring rotor
does not rotate.
1.
CAUTIONS:
Make sure that the clockspring pins are
not bent or damaged.
Make sure that the clockspring rotor
does not rotate.
2.
NOTE: This step is only necessary when
installing a new component.
3.
CAUTION: Make sure that the
clockspring pins are not bent or damaged.
NOTE: This step is not necessary when
installing a new component.
Carry out the clockspring adjustment procedure,
if the yellow roller is not visible in the clockspring
window.
Refer to:
Clockspring Adjustment
(501-20B
Supplemental Restraint System, General
Procedures).
4. To install, reverse the removal procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст