Ford Galaxy / Ford S-MAX. Manual — part 793
22. Template
for RHD
vehicles,
right-
hand
headlamp
23. Template
for RHD
vehicles,
left-hand
headlamp
Exterior Lighting - Headlamp Masking—
Vehicles With: Cornering Lamps
S-MAX/Galaxy 2006.5 (02/2006-)
General Procedures
1. Print out the corresponding templates at the end of
this operation.
2. Measure dimension X on the printout of the
template.
3. Calculate the enlargement/reduction factor Y for
the photocopier using the following formula:
Y=Z÷X×100.
4.
X = measurement on the printout of the
template in mm
Y = enlargement/reduction factor in %
Z = original dimension in mm = 100
5. Enlarge/reduce the printout with a photocopier by
the calculated percentage.
6. Compare dimension X on the photocopy with the
original dimension.
7. Cut out the prepared template for the headlamp.
8. Align the template on the lens of the headlamp.
9.
1. Template
2. Alignment edges on the headlamp lens
10. Align the template on the lens of the headlamp.
11.
1. Template
2. Alignment edges on the headlamp lens
12.
CAUTION: Take extra care not to scratch
the headlamp lens.
Copy the outline of the template with a suitable
pen onto the headlamp lens.
13. Remove the template.
14. Mask the marked area with opaque black adhesive
tape.
15. Repeat steps 12 to 14 for the headlamp on the
other side.
16. Template
for the
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст