Ford Galaxy / Ford S-MAX. Manual — part 880

Procedures).

3. Configure the GEM.

Refer to:

Module Configuration

(418-01 Module

Configuration, General Procedures).

4. Programme the key of the passive anti-theft

system (PATS).

Refer to:

Key and Remote Transmitter

Programming Using Diagnostic Equipment

(419-

01B Anti-Theft - Passive, General Procedures).

5. Program the remote unlocking remote control.

Refer to:

Remote Keyless Entry (RKE)

Transmitter Programming

(501-14 Handles,

Locks, Latches and Entry Systems, General
Procedures).

Multifunction Electronic Modules - Front
Door Module (FDM)

S-MAX/Galaxy 2006.5 (02/2006-)

Print

Removal and Installation

Removal

Installation

1. Remove the front door trim.

Refer to:

Front Door Trim Panel

(501-05 Interior

Trim and Ornamentation, Removal and
Installation).

2.

1. To install, reverse the removal procedure.

2. Configure the FDM.

Refer to:

Module Configuration

(418-01 Module

Configuration, General Procedures).

3. Initialize the window winder motor.

Refer to:

Door Window Motor Initialization

(501-

11 Glass, Frames and Mechanisms, General
Procedures).

Multifunction Electronic Modules - Rear
Door Module (RDM)

S-MAX/Galaxy 2006.5 (02/2006-)

Print

Removal and Installation

Removal

Installation

1. Remove the rear door trim panel.

Refer to:

Rear Door Trim Panel

(501-05 Interior

Trim and Ornamentation, Removal and
Installation).

2.

1. To install, reverse the removal procedure.

2. Configure the RDM.

Refer to:

Module Configuration

(418-01 Module

Configuration, General Procedures).

3. Initialize the window winder motor.

Refer to:

Door Window Motor Initialization

(501-

11 Glass, Frames and Mechanisms, General
Procedures).

Multifunction Electronic Modules - Rear
Door Module (RDM)

S-MAX/Galaxy 2006.5 (02/2006-)

Print

Removal and Installation

Removal

Installation

1. Remove the rear door trim panel.

Refer to:

Rear Door Trim Panel

(501-05 Interior

Trim and Ornamentation, Removal and
Installation).

2.

1. To install, reverse the removal procedure.

2. Configure the RDM.

Refer to:

Module Configuration

(418-01 Module

Configuration, General Procedures).

3. Initialize the window winder motor.

Refer to:

Door Window Motor Initialization

(501-

11 Glass, Frames and Mechanisms, General
Procedures).