Ford Galaxy / Ford S-MAX. Manual — part 879
CPL42A (BK) between the driver door module and the
driver door lock with the aid of the Wiring Diagrams.
CHECK the operation of the system.
K6: CHECK FOR SHORT TO GROUND BETWEEN THE DRIVER DOOR MODULE AND THE
DRIVER DOOR LOCK
Measure the resistance between the driver door
module connector C5PL01-B pin 5, circuit CPL43A
(BK), wiring harness side and ground.
1
Is a resistance of more than 10,000 ohms measured?
Yes
GO to K7
.
No
LOCATE and REPAIR the short to ground in circuit
CPL43A (BK) between the driver door module and the
driver door lock with the aid of the Wiring Diagrams.
CHECK the operation of the system.
K7: CHECK THE VOLTAGE AT THE DRIVER DOOR LOCK (DURING LOCKING)
Connect driver door module C5PL01-B.
1
Measure the voltage between the driver door lock
connector C5PL63 pin 3, circuit CPL43A (BK), wiring
harness side and the driver door lock connector
C5PL63 pin 2, circuit CPL42A (BK), wiring harness
side.
2
Lock the vehicle using the passenger compartment
locking switch.
3
Is a voltage of more than 3.5 V measured?
Yes
GO to K8
.
No
CHECK and if necessary INSTALL a new driver door
module. CHECK the operation of the system.
K8: CHECK THE VOLTAGE AT THE DRIVER DOOR LOCK (DURING UNLOCKING)
Measure the voltage between the driver door lock
connector C5PL63 pin 3, circuit CPL43A (BK), wiring
harness side and the driver door lock connector
C5PL63 pin 2, circuit CPL42A (BK), wiring harness
side.
1
Unlock the vehicle using the passenger compartment
locking switch.
2
Is a voltage of less than 1.5 V measured?
Yes
CHECK and if necessary INSTALL a new driver door
lock. CHECK the operation of the system.
No
CHECK and if necessary INSTALL a new driver door
module. CHECK the operation of the system.
Multifunction Electronic Modules -
Passenger Door Module (PDM)
S-MAX/Galaxy 2006.5 (02/2006-)
Diagnosis and Testing
REFER to: Modul - Fahrertür (DDM) (419-10, Diagnosis and Testing).
Multifunction Electronic Modules - Generic
Electronic Module (GEM)
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Removal
CAUTIONS:
Modules must not be swapped between vehicles.
If a new electric box is installed, make sure that the assignments are the same as on
the removed electric box.
Installation
1. Refer to:
Battery Disconnect and Connect
(414-
01 Battery, Mounting and Cables, General
Procedures).
2.
3.
4.
1. To install, reverse the removal procedure.
2. Programme the GEM.
Refer to:
Programmable Module Installation
(418-01 Module Configuration, General
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст