Ford Galaxy / Ford S-MAX. Manual — part 152
3. Torque:
10 Nm
20 Nm
Stage 1:
Stage 2:
4.
WARNING: Take extra care when handling the
compressed spring.
1. Torque: 10 Nm
2. Torque: 10 Nm
3. Special Tool(s):
205-072
,
205-072-01
Torque:
25 Nm
5. Material:
Silicone Sealant LB (WSE-M4G323-A4 / 2U7J
M4G323-AA)
6.
1.
CAUTION: Make sure that the components
are aligned.
NOTE: Only tighten the bolts finger tight at this
stage.
General Equipment:
Round-ended steel rule
2. Torque: 20 Nm
7.
CAUTION: Only rotate the crankshaft clockwise.
Rotate the crankshaft until piston No. 1 is approximately 20
mm before top dead center (TDC).
8. Install
Torque:
7 Nm
15 Nm
55 Nm
90°
90°
Stage 1:
Stage 2:
Stage 3:
Stage 4:
Stage 5:
9.
CAUTION:
Make sure
that the
components
are installed
to the position
noted before
removal.
Install the
camshafts
approximately at
valve overlap
position cylinder
No. 4.
10. Tighten each
bolt 2 turns at a
time.
Material:
Oil - 5W-
(WSS-M2C913
C)
Torque:
7 Nm
16 Nm
Stage 1:
Stage 2:
11. Install the Special Tool(s):
303-1504
12. Tighten each bolt 2 turns at a time.
Torque:
7 Nm
16 Nm
Stage 1:
Stage 2:
13.
CAUTION: Make sure that the components are
installed to the position noted before removal.
Torque:
10 Nm
14. Torque: 10 Nm
15. Torque: 10 Nm
16.
CAUTION: Make sure that a new friction washer is
installed.
17.
CAUTION: Make sure that the components are
installed to the position noted before removal.
NOTE: Only tighten the bolts finger tight at this stage.
18. General Equipment:
2 mm punch
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст