Ford Galaxy / Ford S-MAX. Manual — part 1098
Installation
1. Special Tool(s):
205-316A
2. Support the rear subframe and install the rear
subframe bolts.
General Equipment:
Transmission jack
Torque:
110 Nm
3.
4. General Equipment:
Transmission jack
5. Install the spacer. Make sure that the spacer is
in a vertical plane and raise the suspension to
the design height setting on both sides.
6. On both sides.
Torque:
130 Nm
7. On both sides.
Torque:
130 Nm
8.
NOTE: Make sure that these components are
installed to the noted removal position.
Torque:
8 Nm
9. Torque: 48 Nm
10. Install the following items:
1. Install the spring, on both sides.
Refer to:
Spring
(204-02 Rear Suspension,
Removal and Installation).
2. Install the stabilzer bar link, on both sides.
Refer to:
Rear Stabilizer Bar Link
(204-02
Rear Suspension, Removal and
Installation).
11. Check the toe setting and adjust as necessary.
Refer to:
Rear Toe Adjustment
(204-00
Suspension System - General Information,
General Procedures).
Refer to:
Specifications
(204-00 Suspension
System - General Information, Specifications).
Uni-Body, Subframe and Mounting System
- Rear Subframe Front Bushing
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Special Tool(s)
General Equipment
Removal
204-598
Hydraulic Cylinder 10t
204-598-01
Remover/Installer, Subframe Bushing Guide
205-316A
Alignment Pins, Subframe
Transmission jack
1. Fabricate two spacers.
2. Remove the spring, on both sides.
Refer to:
Spring
(204-02 Rear Suspension,
Removal and Installation).
3. Install the bolt, on both sides.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст