Ford Galaxy / Ford S-MAX. Manual — part 80
Installation
6.
CAUTION: Make sure that all openings are
sealed.
7.
CAUTION: Make sure that all openings are
sealed.
2. Torque: 18 Nm
3. Torque: 25 Nm
1.
NOTE: Make sure that the seal is correctly located.
To install, reverse the removal procedure.
2. Bleed the brake system.
Refer to:
Brake System Bleeding
(206-00 Brake System
- General Information, General Procedures).
Refer to:
Brake System Pressure Bleeding
(206-00
Brake System - General Information, General
Procedures).
Hydraulic Brake Actuation - Brake Master
Cylinder—RHD FWD
S-MAX/Galaxy 2006.5 (02/2006
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to:
Brake System Health and Safety Precautions
(100-00 General Information, Description and
Operation).
2.
3.
1. Connect one end of a suitable piece of clear plastic
pipe to the brake caliper bleed nipple and place
the other end into a suitable container.
2. Loosen the bleed nipple.
3. Depress the brake pedal until all the brake fluid is
drained from the brake fluid reservoir.
4. Tighten the bleed nipple.
5. Repeat the draining procedure on the opposite
side brake caliper.
4.
3. Detach
the A
pillar
exterior
trim
lower
retaining
clips.
5.
Installation
6.
CAUTION: Make sure that all openings are
sealed.
7.
CAUTION: Make sure that all openings are
sealed.
2. Torque: 18 Nm
3. Torque: 25 Nm
1.
NOTE: Make sure that the seal is correctly located.
To install, reverse the removal procedure.
2. Bleed the brake system.
Refer to:
Brake System Bleeding
(206-00 Brake System
- General Information, General Procedures).
Refer to:
Brake System Pressure Bleeding
(206-00
Brake System - General Information, General
Procedures).
Hydraulic Brake Actuation - Brake Pedal
and Bracket—LHD FWD
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 10 Nm
2.
CAUTION: Make sure that the brake
pedal remains in the rest position.
3.
CAUTIONS:
Make sure that the brake pedal remains
in the rest position.
The brake pedal actuating rod pin will be
damaged during removal.
Torque:
24 Nm
4. Torque: 24 Nm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст