Ford Galaxy / Ford S-MAX. Manual — part 909

GO to H11

.

No

INSTALL a new climate controlled seat wiring
harness. TEST the system for normal operation.

H11: CHECK FOR VOLTAGE TO THE INOPERATIVE CLIMATE CONTROLLED SEAT FRONT
SEAT BACKREST FAN

Ignition switch in position II.

1

While operating the climate controlled seat switch,
measure the voltage between the front seat

backrest fan connector pin 1, (RD/BK), harness side
and ground.

2

Is the voltage greater than 6 volts?
Yes

INSTALL new climate controlled front seat backrest
fan.
REFER to:

Front Seat Backrest

(501-10 Seating,

Disassembly and Assembly).
TEST the system for normal operation.

No

GO to H13

.

H12: CHECK FOR CONTINUITY BETWEEN THE INOPERATIVE CLIMATE CONTROLLED
SEAT CUSHION FANS AND THE CLIMATE CONTROLLED SEAT MODULE

Ignition switch in position 0.

1

Disconnect Inoperative Climate Controlled Seat
Module.

2

Measure the resistance between the climate
controlled seat module connector pin 6, (RD),

harness side and the front seat cushion fan
connector pin 1, (RD), harness side.

3

Is the resistance less than 5 ohms?
Yes

INSTALL a new climate controlled seat module.
TEST the system for normal operation.

No

INSTALL a new climate controlled seat wiring
harness. TEST the system for normal operation.

H13: CHECK FOR CONTINUITY BETWEEN THE INOPERATIVE CLIMATE CONTROLLED
SEAT BACKREST FANS AND THE CLIMATE CONTROLLED SEAT MODULE

Ignition switch in position 0.

1

Disconnect Inoperative Climate Controlled Seat
Module.

2

Measure the resistance between the climate
controlled seat control module connector pin 1,

(BK/RD), harness side and the front seat backrest
fan connector pin 1, (RD/BK), harness side.

3

Is the resistance less than 5 ohms?
Yes

INSTALL a new climate controlled seat module.
TEST the system for normal operation.

No

INSTALL a new climate controlled seat wiring
harness. TEST the system for normal operation.

Seating - Front Seat

S-MAX/Galaxy 2006.5 (02/2006-)

Print

Removal and Installation

Removal

WARNINGS:

The supplemental restraint system (SRS) is active for a certain length of time after

the power supply has been disconnected. Wait for a minimum of 3 minutes before
disconnecting or removing any SRS components.

Make sure that the vehicle electrical system is fully depowered and no other power

source is connected.
NOTE: Removal steps in this procedure may contain installation details.

1.

2. Torque: 40 Nm

3. Refer to:

Battery Disconnect and Connect

(414-

01 Battery, Mounting and Cables, General
Procedures).

4. Torque: 40 Nm

5.

Installation

1. To install, reverse the removal procedure.