Ford Galaxy / Ford S-MAX. Manual — part 34
Vehicles with 1.6L engine
All vehicles
14.
15. General Equipment:
Transmission jack
16.
17.
WARNING: This step requires the aid of
another technician.
Lower the front subframe to gain access to the
stabilizer bar bolts.
18. Remove the stabilizer bar nuts on both sides. Do not
remove the stabilizer bar bolts at this stage.
19.
NOTE: Note the position of each component before
removal.
Installation
All vehicles
1. Install the stabilizer bar bushings with no lubricant.
Make sure the bushing nipple is on the right-hand
side.
2.
NOTE:
Make sure
that the
clamp is
installed
to the
same
orientation
as when
removed.
On both
sides.
3.
NOTE: Apply water to the stabilizer bar clamp to
assist installation.
On both sides.
General Equipment:
Hydraulic press
4. Install new nuts and bolts, on both sides.
Torque:
140 Nm
45°
Stage 1:
Stage 2:
Vehicles with 2.5L engine
Vehicles with 2.0L or diesel engine
Vehicles with 1.6L engine
5.
1. Insert the washer, with inside diameter 22 mm,
outside diameter 44 mm and height 5 mm, into
the front subframe above the alignment hole.
2. Insert the alignment pin through the front
subframe alignment holes and the washer.
Special Tool(s):
205-316A
3. Slide the locking plates on top of the washer and
into the groove of the special tool and tighten
the alignment pin sleeve.
6. Torque:
150 Nm
90°
Stage 1:
Stage 2:
7.
1. Torque: 30 Nm
2. Torque:
150 Nm
90°
Stage 1:
Stage 2:
8. Torque: 110 Nm
9. Torque: 80 Nm
10. Torque: 80 Nm
All vehicles
Vehicles with 1.6L engine
All vehicles
11.
12.
13.
CAUTION: Make sure that the exhaust flexible
pipe is not forcibly bent.
14.
CAUTION: Make sure that the ball joint ball
does not rotate.
On both sides.
Torque:
70 Nm
15. Special Tool(s):
307-242
,
308-440
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст