Ford Galaxy / Ford S-MAX. Manual — part 990
Supplemental Restraint System - Driver Air
Bag Module—Vehicles Built From: 13-07-
2009
S-MAX/Galaxy 2006.5 (02/2006
Removal and Installation
General Equipment
Removal
WARNINGS:
The supplemental restraint system (SRS) is active for a certain length of time after the
power supply has been disconnected. Wait for a minimum of 3 minutes before disconnecting or
removing any SRS components.
Make sure that the vehicle electrical system is fully depowered and no other power source
is connected.
NOTE: Removal steps in this procedure may contain installation details.
NOTE: Make sure that the steering column lock is not engaged.
Flat-bladed screwdriver
1. Refer to:
Supplemental Restraint System (SRS) Health
and Safety Precautions
(100-00 General Information,
Description and Operation).
2. Refer to:
Battery Disconnect and Connect
(414-01
Battery, Mounting and Cables, General Procedures).
3. General Equipment:
Flat-bladed screwdriver
4.
5.
General Equipment:
Flat-bladed screwdriver
6.
General
Equipment:
Flat-bladed
screwdriver
7.
General
Equipment:
Flat-bladed
screwdriver
Installation
8.
9.
General
Equipment:
Flat-bladed
screwdriver
1. To install, reverse the removal procedure.
Supplemental Restraint System - Driver
Lower Air Bag Module
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Removal
WARNINGS:
The supplemental restraint system (SRS) is active for a certain length of time after
the power supply has been disconnected. Wait for a minimum of 3 minutes before
disconnecting or removing any SRS components.
Wear safety goggles.
Do not probe supplemental restraint system (SRS) electrical connectors.
Refer to:
Supplemental Restraint System (SRS) Health and Safety Precautions
(100-
00 General Information, Description and Operation).
1. Disconnect the battery ground cable.
Refer to:
Battery Disconnect and Connect
(414-
01 Battery, Mounting and Cables, General
Procedures).
2.
3.
4.
CAUTION: The component must only be
removed by pushing from behind.
Release the clips and at the same time push on
the back of the air bag module.
5.
CAUTION: The component must only be
removed by pushing from behind.
Release the clips and at the same time push on
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст