Ford Aspire (1997 year). Manual — part 47
186
Removing the headlamp bulb
1.
Make sure that the headlamp knob is in the
OFF position.
2.
Lift the hood and find the bulb in the
headlamp socket.
3.
Remove the electrical connector from the
bulb housing by pushing the locking tabs on
either side and pulling out the connector.
4.
Remove the retaining ring by turning it 1/8
of a turn to free it from the socket. Then
slide the ring off.
Keep the ring.
You must
use it again to hold the new bulb in place.
5.
Remove the rubber boot. Save it because
you’ll need it to cover the new bulb.
6.
Release the metal retaining clip that holds
the bulb in place.
7.
Carefully remove the bulb assembly from its
socket by gently pulling the assembly
rearward without turning.
187
Headlamp bulb assembly location
Headlamp bulb assembly removal
188
Installing the headlamp bulb
1.
Insert the glass end of the bulb assembly
into the socket.
2.
Secure the bulb assembly in place with the
metal retaining clip.
3.
Attach the rubber boot over the bulb
assembly.
4.
Slip the bulb retaining ring over the boot
and bulb assembly. Lock the ring into the
socket by rotating it clockwise until you feel
a “stop”.
5.
Push the electrical connector into the rear of
the bulb assembly until it locks into position.
6.
Turn the headlamps on and make sure they
work properly. If the headlamp was
correctly aligned before you changed the
bulb, you should not need to align it again.
189
Rear Lamp Bulbs
To replace a bulb:
1.
Raise the liftgate.
2.
Remove the two lamp screws.
3.
Press the rear lamp toward the outside of
the vehicle to disengage it from the body.
4.
Pull the rear lamp away from the body to
expose the lamp bulb sockets.
Большое спасибо!
Ваше мнение очень важно для нас.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст