Ford Aspire (1997 year). Manual — part 46
182
WARNING
Do not park, idle, or drive your vehicle in
dry grass or other dry ground cover. The
emission system heats up the engine
compartment and exhaust system, which
can start a fire.
Watch for fluid leaks, strange odors, smoke, loss
of oil pressure, the charge warning light, the
check engine light, or the temperature warning
light. These sometimes indicate that the emission
system is not working properly.
Do not make any unauthorized changes to your
vehicle or engine. Changes that cause more
unburned fuel to reach the exhaust system can
increase the temperature of the engine or
exhaust system.
In general, maintenance, replacement, or service
of the emissions control devices or systems in
your new Ford Motor Company vehicle or
engine may be performed at your expense by
any automotive repair establishment or
individual using automotive parts equivalent to
those which your vehicle or engine was
originally equipped.
If other than Ford or Motorcraft or Ford
authorized remanufactured parts are used for
maintenance, replacement, or for the service of
components affecting emissions control, the
owner should be assured that such parts are
warranted by their manufacturer to be
equivalent to genuine Ford Motor Company
parts in performance and durability. Please
consult your warranty information booklet for
complete warranty information.
183
By law, anyone who manufactures, repairs,
services, sells, leases, trades vehicles, or
supervises a fleet of vehicles is not permitted to
intentionally remove an emission control device
or prevent it from working. In some of the
United States and in Canada, vehicle owners
may be liable if their emission control device is
removed or is prevented from working.
Never use a metal exhaust collector when you
service your vehicle. If the metal collector
contacts any of your vehicle’s plastic trim or
bumper parts they could melt or deform.
Do not drive your vehicle if it does not operate
properly. See your dealer if the engine runs on
for more than five seconds after you shut it off
or if it misfires, surges, stalls, or backfires.
Information about your vehicle’s emission
control system is on the Vehicle Emission
Control Information decal located on or near the
engine. This decal identifies engine displacement
and gives some tune-up specifications.
How to Prepare Your Vehicle for
Inspection/Maintenance (I/M) Testing
In some localities it may become a legal
requirement to pass an
Inspection/Maintenance (I/M) test of the
On-Board Diagnostic (OBD) II system. If your
“Check Engine” light is on, reference the “Check
Engine” light description under the Warning
Lights and Gauges section. Your vehicle may not
pass an I/M test with the Check Engine light on.
If the vehicle’s powertrain system or its battery
has just been serviced, the OBD II system is
reset to a not ready for for I/M testing
condition. To prepare for I/M testing, additional
mixed city and highway driving to complete the
check of the OBD II system is necessary.
184
The driving modes required to reach the ready
condition consist of a minimum of 30 minutes of
city and highway driving as described below:
❑
20 minutes of driving in stop and go
city-type traffic with at least four idle periods.
❑
10 minutes of driving on an expressway or
highway.
Before completing the above driving modes, the
engine must be warmed up and at operating
temperature. Once started, the vehicle must not
be turned off during the above driving modes. If
the vehicle owner is unable to meet the I/M
requirements by using these driving patterns, an
authorized service center can perform a detailed
OBD II drive cycle as it would any other type of
repair work.
Lights and Bulb Replacement
It is a good idea to check the operation of the
following lights frequently:
❑
headlamps
❑
high mount brakelamp
❑
tail lamps
❑
brakelamps
❑
hazard flasher
❑
turn signals
❑
side markers
❑
license plate lamps
❑
fog lamps
185
The alignment of your headlamps should be
checked if:
❑
oncoming motorists frequently signal you to
turn off your vehicle’s high beams when you
do not have the high beams on
❑
the headlamps do not seem to give you
enough light to see clearly at night
❑
the headlamp beams are pointed substantially
away from a position slightly down and to
the right
Headlamp Bulb
The headlamps on your vehicle use replaceable
bulbs. When the lamp burns out, simply replace
the bulb, rather than the whole lamp.
WARNING
Handle a halogen headlamp bulb carefully
and keep out of children’s reach. Grasp
the bulb only by its plastic base and do
not touch the glass. The oil from your
hand could cause the bulb to break the
next time the headlamps are operated.
Do not remove the burned-out bulb unless you
can immediately replace it with a new one. If a
bulb is removed for an extended period of time,
contaminants may enter the headlamp housing
and affect its performance.
Большое спасибо!
Ваше мнение очень важно для нас.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст