Ford Ranger EV (2001 year). Manual — part 188
414-03B-148
414-03B-148
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
414-03B-149
414-03B-149
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
Traction Battery Module — Modules 10, 11, 12, 23, 24
Special Tool(s)
Battery Post Torque Wrench
307-026
Battery Terminal Cap Opener
418-F215
Battery Handles
414-F001
Removal
1. This procedure contains steps specific to the
modules listed. Do not start with this procedure.
Refer to
Traction Battery Module Replacement
2. Remove the high and low-voltage harness push
pins.
414-03B-150
414-03B-150
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
3. Unclip the battery hold down tie bar cover.
1 Unclip and disconnect the sensor lead
electrical connectors.
2 Unclip the cover.
4. Unclip the battery hold down tie bar cover.
1 Unclip and disconnect the sensor lead
electrical connector.
2 Unclip the relay.
3 Unclip the cover.
5. Remove the battery hold down strap bolt and
pull the straps back off the battery hold down
tie bar.
6. Remove the battery hold down tie bar.
414-03B-151
414-03B-151
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
7. Remove the battery hold down strap bolt and
pull the straps back off the battery hold down
tie bar.
8. Remove the battery hold down tie bar.
9. NOTE: If removing module 12, disconnect the
two thermistors.
Disconnect the necessary module.
•
Disconnect the HVJ cables and discard the
nuts.
10. Using the special tool, remove the module.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст