Ford Ranger EV (2001 year). Manual — part 189
414-03B-152
414-03B-152
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
Installation
1. NOTE: The arrow on the battery hold down tie
bars must be pointed towards the front of the
traction battery.
To install, reverse the removal procedure.
•
Fill the high-voltage jumper connectors with
Nyogel after final tightening of the nuts.
414-03B-153
414-03B-153
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
Traction Battery Module — Modules 13-15
Special Tool(s)
Battery Post Torque Wrench
307-026
Battery Terminal Cap Opener
418-F215
Battery Handles
414-F001
Removal
Modules 13-15
1. This procedure contains steps specific to the
modules listed. Do not start with this procedure.
Refer to
Traction Battery Module Replacement
2. Remove the high and low-voltage harness push
pins.
414-03B-154
414-03B-154
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
3. Unclip the battery hold down tie bar cover.
1 Unclip and disconnect the sensor lead
electrical connector.
2 Unclip the relay.
3 Unclip the cover.
4. Remove the battery hold down strap bolt and
pull the straps back off the battery hold down
tie bar.
5. Remove the battery hold down tie bar.
Modules 13,14
6. Disconnect the 14+ and 13- HVJs.
•
Disconnect the HVJ cables and discard the
nuts.
414-03B-155
414-03B-155
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
7. Remove the battery hold down bracket.
1 Remove the bolts.
2 Remove the bracket.
8. Remove the battery hold down bracket.
1 Remove the bolts.
2 Remove the bracket.
Module 15
9. Remove the battery hold down bracket.
1 Remove the bolts.
2 Remove the bracket.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст