Ford Ranger EV (2001 year). Manual — part 185
414-03B-136
414-03B-136
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
5. Install the module. Refer to the appropriate
procedure.
6. Install the traction battery cover.
•
Install the 22 bolts.
Traction Battery Module — Modules 2-6
Special Tool(s)
Battery Post Torque Wrench
307-026
Battery Terminal Cap Opener
418-F215
Battery Handles
414-F001
414-03B-137
414-03B-137
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
Removal
1.
CAUTION: Module replacement
requires a special charging procedure that is
incorporated into the removal and
installation of the module. To replace a
faulty module, follow the Traction Battery
Module Replacement located in the General
Procedures section of this manual.
Refer to
Traction Battery Module Replacement
2.
CAUTION: Disconnect only one HVJ
at a time.
Disconnect the HVJs from the contactor box.
•
Open the cap.
•
Remove and discard the nut.
3. Wrap the HVJ ends with orange electrical tape.
4. Remove the two-pin high-voltage connector
nuts.
414-03B-138
414-03B-138
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
5. Disconnect the high-voltage interlock electrical
connector.
6. Disconnect the low-voltage electrical connector.
7. Position the contactor box towards the front of
the traction battery.
8. Remove the composite bars.
1 Unclip the connectors.
2 Remove the bolts.
3 Remove the composite bars.
414-03B-139
414-03B-139
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
9. Remove the rear module hold down bracket.
1 Remove the bolts.
2 Remove the hold down.
10. Unclip the battery hold down tie bar.
1 Remove the pushpins.
2 Unclip the cover.
11. Remove the battery hold down strap bolt and
pull the straps back off the battery hold down
tie bar.
12. Disconnect the 6+ HVJ.
•
Remove and discard the nut.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст