Ford Ranger EV (2001 year). Manual — part 36
206-05-5
206-05-5
Parking Brake and Actuation
REMOVAL AND INSTALLATION (Continued)
2. Install the backing plate.
1 Position the backing plate.
2 Install two new rivets.
3 Install the three bolts.
3. Assemble the parking brake linkage.
4. NOTE: Position the linkage that connects to the
cable facing down.
Install the parking brake linkage.
206-05-6
206-05-6
Parking Brake and Actuation
REMOVAL AND INSTALLATION (Continued)
5. Connect the parking brake cable.
6. Install the inside upper brake shoe spring on the
brake shoes.
7. NOTE: The inside upper brake shoe spring
must be installed prior to positioning the brake
shoes.
Position the brake shoes and install the adjuster
and spring.
1 Install the retaining clips.
2 Position the adjuster and install the spring.
8. Use Brake Adjusting Gauge to measure the
inside diameter of the drum portion of the rear
disc brake rotor.
206-05-7
206-05-7
Parking Brake and Actuation
REMOVAL AND INSTALLATION (Continued)
9. Use Brake Adjusting Gauge to set the rear
brake shoe and lining to 0.508 mm (0.02 in)
less than the inside diameter of the drum
portion of the rear disc brake rotor.
•
Rotate the adjusting screw as necessary.
10. Position the parking brake cable in the bracket.
11. Install the hub. Refer to
Parking Brake Cables —Front
Removal
1. The parking brake control cables on the Electric
Ranger are carryover from the standard Ranger.
Refer to Section 206-05 of the 2001 Ranger
Workshop Manual.
Parking Brake Cables —Postal Ranger EV
Removal and Installation
1. Raise and support the vehicle. For additional
information, refer to
206-05-8
206-05-8
Parking Brake and Actuation
REMOVAL AND INSTALLATION (Continued)
2. Remove the front cable from the bracket.
3. Remove the front cable from the rear cable.
4. Remove the front cable hold-down bolt.
5. Lower the vehicle.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст