Ford Ranger EV (2001 year). Manual — part 47
211-02-9
211-02-9
Power Steering
DIAGNOSIS AND TESTING (Continued)
PINPOINT TEST D: STEERING WHEEL SHUDDER
TEST STEP
ACTION TO TAKE
•
With vehicle parked and key ON, rotate the steering wheel from
Yes =
REMOVE power steering
lock-to-lock.
reservoir cap and use
Vacuum Tester to purge air
from the power steering
system while rotating the
steering wheel from
lock-to-lock, or ROTATE
steering wheel from
lock-to-lock until shudder
stops.
•
Does steering wheel shudder?
No =
System OK.
REMOVAL AND INSTALLATION
Power Steering Assembly
Removal
1. Disconnect the traction battery auxiliary lead
high-voltage connector. Refer to
Section
2. Disconnect the power steering assembly
electrical connectors.
3. Disconnect the power steering assembly pump
lines.
•
Clamp the reservoir hose to prevent fluid
loss.
211-02-10
211-02-10
Power Steering
REMOVAL AND INSTALLATION (Continued)
4. Remove the power steering controller assembly.
1 Remove the nuts.
2 Remove the assembly.
Installation
1. To install, reverse the removal procedure.
•
Purge the power steering system of air.
Refer to Section 211-00 of the 2001
Ranger Workshop Manual.
Power Steering Gear
Removal
211-02-11
211-02-11
Power Steering
REMOVAL AND INSTALLATION (Continued)
2. NOTE: The A/C system is not evacuated for
this procedure.
Remove the two front A/C compressor bolts.
3. NOTE: The traction battery has been removed
for clarity.
Remove the two rear A/C compressor bolts.
4.
CAUTION: Do not force the
compressor into position, or damage to the
A/C lines may result.
Raise and support the compressor using a 9.5
mm (3/8 in) diameter, 900 mm (36 in) long
rod.
•
Lift the compressor high enough to slide the
rod over the vehicle frame and under the
compressor.
5. Remove the front section of the A/C
compressor bracket.
1 Remove the two bolts.
2 Remove the two bolts.
3 Remove the bracket.
211-02-12
211-02-12
Power Steering
REMOVAL AND INSTALLATION (Continued)
6. NOTE: The traction battery has been removed
for clarity.
Remove the two rear bracket bolts.
7. Remove the rear half of the A/C compressor
bracket.
8. The power steering gear is the same as the
gasoline powered Ranger. Remove the power
steering gear. Refer to the 2001 Ranger
Workshop Manual.
Installation
1. To install, reverse the removal procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст