Ford Falcon. Manual — part 240
307-01-63 Automatic
Transmission 307-01-63
REMOVAL AND INSTALLATION (Continued)
15. Remove the transmission control lever from the
transmission cross shaft.
16. Remove the converter housing to cylinder block
bolts.
17. Hold the converter firmly against the transmission,
move the transmission rearward and lower.
Secure the converter to the transmission and
remove the assembly from under the vehicle.
Installing Transmission - 93LE
Item
Description
1
Transmission case
2
Lubricant ESA-MK-75B
3
Bolt M12x55
G73113 en
307-01-64 Automatic
Transmission 307-01-64
REMOVAL AND INSTALLATION (Continued)
Installing Transmission - 93LE
Item
Description
1
Transmission case
2
Bolt M10x50
3
Bolt M10x18
4
Cover flywheel
G73113 en
307-01-65 Automatic
Transmission 307-01-65
REMOVAL AND INSTALLATION (Continued)
Installing Transmission - 97LE
13. Connect the inhibitor switch, speedometer
Item
Description
transducer (if fitted) and solenoid wiring. Ensure
1
Transmission case
that the inhibitor switch 2 pin plug and breather
2
Bolt M12x55
tube are sealed. Attach the inhibitor switch shield.
3
Wiring retainer
14. Install the drive shaft. Match the alignment marks
and secure the flange bolts.
Installation
NOTE: When disconnecting or removing the
1. With the converter properly installed on the
driveshaft it is essential that the position of the
transmission, place it on the jack and install the
slip yoke relative to the output shaft and position
safety chain.
of the companion flange hardware be identified as
2. Raise the transmission into position.
illustrated. Failure to return all parts to their
original position may induce driveline vibration.
3. Install the transmission to engine attaching bolts.
4. Install the converter to flywheel bolts. Install the
15. Install the catalytic converter assembly.
converter housing cover and engine to body earth 16. Connect the park brake cable.
cable.
17. Lower the vehicle.
5. Install the starter motor.
18. Connect the battery.
6. Loosely connect the transmission cooler pipes.
19. Check the fluid level and top up with approved
7. Install the mass damper and rear mount on the
fluid as required (see Transmission Fluid Level
extension housing.
Check).
8. Detach the safety chain, raise the transmission
20. Check the operation of the transmission controls.
and install the transmission cross member.
21. Carry out the ’Throttle Learn’ procedure.
9. Remove the jack.
10. Tighten the cooler line unions.
11. Install the control lever on the transmission cross
shaft.
12. Check the gear shift cable adjustment (refer
section 307-05).
G73113 en
307-01-66 Automatic
Transmission 307-01-66
REMOVAL AND INSTALLATION (Continued)
22. If a new transmission has been installed the PCM
must be configured using an WDS tester and the
Service Card:
Enter SERVICE BAY FUNCTIONS
Select PCM
Select TRANSMISSION CONFIGURE (1)
This procedure ensures that the line pressure
is regulated to correspond with a green/new
transmission.
G73113 en
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст