Ford Falcon. Manual — part 238
307-01-55 Automatic
Transmission 307-01-55
REMOVAL AND INSTALLATION (Continued)
V8 Steering column components
G73102 en
307-01-56 Automatic
Transmission 307-01-56
REMOVAL AND INSTALLATION (Continued)
Gear Shift — Floor Mounted
Removal
1. Raise the vehicle and disconnect the transmission
shift cable from the lower selector lever.
I6 Floor mount shift components
G73103 en
307-01-57 Automatic
Transmission 307-01-57
REMOVAL AND INSTALLATION (Continued)
V8 Floor mount shift components
2. Disconnect the four nuts that attach the housing
6. Remove the whole floor shift housing by lifting
to the floorpan.
vertically
Installation
1. To install the floor shift housing to the floorpan
reverse the above instructions in order 6, 5, 4.
2. Place the selector lever in the ‘P’ position.
3. Raise the vehicle.
4. Reconnect the four nuts that attach the housing to
the floorpan.
5. Install the shift cable back onto the lower selector
lever.
6. Tighten the lock nut to the required torque to 28
Nm.
7. Lower the vehicle and check transmission
operation in each selector lever detent position.
3. Lower the vehicle.
8. Check that the mode light functions correctly. For
4. Remove the centre console (Refer to section
further information, refer to Section 307-05.
307-05).
5. Detach the back light bulb/wiring.
G73103 en
307-01-58 Automatic
Transmission 307-01-58
REMOVAL AND INSTALLATION (Continued)
Cross Shaft Seals
Mass Damper / Extension Housing
Special Tool(s)
93 LE (I6)
Selector shift pin remover and
installer
Manual selector shaft seal
remover
Manual selector shaft seal
installer
Removal
1. Raise the vehicle.
2. Detach the transmission lever and/or the inhibitor
switch from the cross shaft. For 93LE only the
external cross shaft pin must be removed using
tool 307-467 prior to removing the inhibitor switch.
3. Carefully remove the seal/s from the case using
special tool 307-365.
Installation
Item
Description
1. Cover the shaft with plastic tape to prevent
1
Nut M8
damage to the seal and using special tool
307-366 drive the new seal into the case until it is
2
I6 AutomaticTransmission Extension
flush with the boss. Remove the tape.
Housing
2. Install the transmission lever and/or inhibitor
3
Extension Housing adapter
switch. For 93LE only install the external cross
4
Support Bracket
shaft pin using tool 307-467 prior to installing the
5
Bolt M10x25
transmission lever.
6
Transmission Support
3. Lower the vehicle.
7
Lock Nut M10
8
Bolt M10x50
9
Cross Member
10
Bolt M8X46
11
Bolt M10x89
G73103 en
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст