Ford Falcon. Manual — part 166
303-01c-85
Engine — V8 (4V)
303-01c-85
ASSEMBLY (Continued)
69. Install the rear oil seal retainer and loosely install
66. Install the lifting bracket special tool.
the six bolts.
NOTE: LH shown, RH similar.
70. Tighten the bolts in the sequence shown.
67. Remove the engine from the work stand.
71. Apply silicone gasket and sealant at the
crankshaft rearseal retainer-to-cylinder block
sealing surface.
NOTE: If the oil pan and the oil pan gasket are
not secured within four minutes, the sealant must
be removed and the sealing area cleaned with
metal surface cleaner. Allow to dry until there is
no sign of wetness, or four minutes, whichever is
longer. Failure to follow this procedure can cause
future oil leakage.
68. Apply a 4 mm (0.16 in) bead of silicone gasket
and sealant around the rear oil seal retainer
sealing surface.
NOTE: If the rear crankshaft seal retaining plate is
not secured within four minutes, the sealant must
be removed and the sealing area cleaned with
metal surface cleaner. Allow to dry until there is
no sign of wetness, or four minutes, whichever is
longer. Failure to follow this procedure can cause
future oil leakage.
NOTE: The silicone must be applied on the
groove along the retainer plate.
G89799 en
303-01c-86
Engine — V8 (4V)
303-01c-86
ASSEMBLY (Continued)
72. Apply silicone gasket and sealant at the engine
74. Tighten the bolts in three stages, in the sequence
front cover-to-cylinder block sealing surface.
shown.
NOTE: If the oil pan and the oil pan gasket are
Stage 1: Tighten to 2 Nm (18 lb-in).
not secured within four minutes, the sealant must
Stage 2: Tighten to 20 Nm (15 lb-ft).
be removed and the sealing area cleaned with
Stage 3: Tighten an additional 60 degrees.
metal surface cleaner. Allow to dry until there is
no sign of wetness, or four minutes, whichever is
longer. Failure to follow this procedure can cause
future oil leakage.
73. Install the oil pan gasket and the oil pan and
loosely install the 16 bolts.
75. Lower the engine onto wooden blocks.
76. Remove the special tool.
G89799 en
303-01c-87
Engine — V8 (4V)
303-01c-87
ASSEMBLY (Continued)
77. Install the oil level indicator and tube, and the
80. Using the special tool, install the crankshaft rear
stud.
oil seal.
78. Install the LH exhaust manifold and gaskets.
81. Using the special tool, install the crankshaft oil
slinger.
Tighten the bolts in the sequence shown.
82. Install the spacer plate.
79. Install the special tool and raise the engine.
G89799 en
303-01c-88
Engine — V8 (4V)
303-01c-88
ASSEMBLY (Continued)
83. Install the bolts and the flywheel.
G89799 en
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст