Ford Falcon. Manual — part 403
501-02-4
Front End Body Panels
501-02-4
GENERAL PROCEDURES
Hood Alignment
Fender Alignment
1. The hood is provided with fore and aft adjustment. 1. Loosen the fender retaining bolts.
These directions refer to the position of the hood
when it is fully lowered. Slots in the hinge provide
fore and aft adjustment.
1.
Raise
the
hood.
2. Adjust the hood bumpers by screwing them in
or out of the panel to prevent over slam and
hood movement.
NOTE: The fenders are set relative to the hood latch
mounting point on the upper cross member during
body assembly. There is no hood latch adjustment
vertically or right to left. If vehicle damage results in a
need to reset the hood margins then the fenders
should be adjusted relative to the hood.
G36752 en
501-02-5
Front End Body Panels
501-02-5
GENERAL PROCEDURES (Continued)
Fender to Bumper
2. Adjust the fender to obtain hood/door margins as
shown below (Alignment Diagrams).
Fender to Bumper
Fender Margins
Fender to Lower Body Panel
Item
Description
1
Fender to Hood
2
Fender to Bumper
3
Fender to Bumper
4
Fender to Lower Body Panel
5
Side Repeater Lamp to Fender
Fender to Hood
G36752 en
501-02-6
Front End Body Panels
501-02-6
GENERAL PROCEDURES (Continued)
Side Repeater Lamp to Fender
3. Tighten the fender bolts to the specified torque.
4. Verfy alignment and repeat procedure if
necessary.
G36752 en
501-02-7
Front End Body Panels
501-02-7
REMOVAL AND INSTALLATION
3. Remove the fender splash shield. Remove the
Air Deflector
retaining scrivets (10 x 6mm), screws and firtree
clips.
Removal
NOTE: There are a total of 2 screws attaching the
1. Remove the 10 attaching screws and 2 plastic
front lower section of the splashshield.
push-in rivets.
NOTE: Adjust torque specifications at the front of
the document.
Item
Description
1
Lower Radiator Deflector Assembly
Item
Description
2
Screw
1
Fender Splash Shield
3
Scrivet
2
Firtree clip 6.5x25mm (2 off)
4
Front Bumper Assembly
3
Scrivets - 6mm (10 off)
2. Slide the deflector rearwards.
4
Screw - 5mm (1 off)
Installation
5
Screw - 5mm (2 off)
1. To install, reverse the removal procedure.
Installation
Fender Splash Shield
1. To install, reverse the removal procedure.
Removal
Cowl Panel Grille
1. Raise and support the vehicle. For additional
information, refer to Section 100-02.
Removal
2. Remove the wheel and tire. For additional
1. Remove the wiper front pivot arms. For additional
information, refer to Section 204-04.
information refer to, Section 501-16.
2. Remove the 5 retaining scrivets.
G36756 en
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст