Ford Probe (1997 year). Manual — part 29
121
7.
Double check that the retractor is in the
automatic locking mode. Try to pull more
belt out of the retractor. If you cannot, the
belt is in the automatic locking mode.
Checking the retractor
8.
Check to make sure that the child seat or
infant carrier is properly secured prior to
each use. If the belt is not locked, repeat
steps 4 through 7.
NOTE:
To remove the retractor from automatic
lock mode, allow seat belt retract fully
to its stowed position and the retractor
will automatically switch back to the
vehicle sensitive locking mode for
normal adult usage.
122
R
WARNING
Carefully follow all of the manufacturer’s
instructions included with the safety seat
you put in your vehicle. If you do not
install and use the safety seat properly,
the child may be injured in a sudden stop
or collision.
Attaching Safety Seats With Tether Straps
Some manufacturers make safety seats that
include a tether strap that goes over the back of
the vehicle seat and attaches to an anchoring
point. Other manufacturers offer the tether strap
as an accessory. Contact the manufacturer of
your child safety seat for information about
ordering a tether strap.
Front Seats
To install a tether from a child safety seat in the
front seat:
1.
Buckle the lap/shoulder belt (in the seat
directly behind the front passenger seat in
which the child safety seat will be installed).
2.
Pull all the stored belt out of the rear seat
retractor to switch the retractor to automatic
locking mode.
3.
Let the retractor wind up the slack from the
lap/shoulder belt. A clicking sound should
be heard as the belt retracts, indicating that
the retractor is in automatic locking mode.
4.
Install the child safety seat in the front seat.
Refer to the previous section on
Installing
Safety Seats
. Hook the tether strap hook
around the webbing near the center of the
shoulder portion of the locked lap/shoulder
belt.
5.
Tighten the tether strap.
123
Rear Seats
If you use a tethered safety seat on one of the
rear seats, install a tether anchor bracket to one
of the two 0.3 inch (8 mm) weld nuts on the
rear of the cargo area below the opening for the
liftgate.
Tether Anchorage Hardware
Tether anchor hardware kits can be obtained at
no charge from any Ford or Lincoln-Mercury
dealer.
Be sure to follow the child safety seat
manufacturer’s instructions.
R
WARNING
Tighten the anchor according to
specifications. Otherwise, the safety seat
may not be properly secured and the child
may be injured in a sudden stop or
collision.
Installing the Anchor Bracket
1.
Open the liftgate and take out the luggage
compartment cover (if equipped).
2.
The anchorage nuts used to secure the tether
anchor are located in the rear body panel
behind the trim at the rear of the luggage
compartment. Remove the trim panel. The
backside of the panel is scored at the
locations of the anchorage nuts. Make a hole
the size of the scoring in the trim panel to
provide access to the anchor nut. The hole
should be made on the same side of the
vehicle as the child safety seat will be
located. Reinstall the trim panel.
124
3.
Install the hardware for anchoring the tether
following the instructions in the tether
anchorage hardware kit.
4.
Re-install luggage compartment cover.
Installing the anchor bracket
Большое спасибо!
Ваше мнение очень важно для нас.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст