Ford Aerostar (1997 year). Manual — part 29
114
Disengaging safety belt for rear seat removal
Whenever a rear seat has been removed, the
tongue end of the detachable anchor must be
correctly stowed. See the following illustration.
115
Rear seat shoulder safety belt — stowage (with seat
removed)
116
R
WARNING
When reinstalling a rear seat in your
vehicle it must be placed in its original
position. Improper installation of the seat
will prevent correct use of the safety belts
and could increase the risk of injury.
Refer to the warning label on the seat
belt.
After installing the rear seat, make sure the
safety belt is not twisted before you insert it into
the detachable anchor. A twisted safety belt may
cause the retractor to not work properly. Then
insert the detachable anchor tongue into the
detachable anchor until you hear a “click” and
feel the latch engage.
Lap Belts
On the center seat of the rear three-passenger
seats you will find a lap-belt without a retractor.
You must adjust the lap belt to fit snugly and as
low as possible around your hips. Do not wear
the lap belt around your waist.
Fastening and unfastening the center rear occupant safety
lap belts
117
Pull the belt across your hips and
insert the
tongue into the correct buckle
on your seat
until you hear a snap and feel it lock. Make sure
the buckle is securely fastened.
If you need to lengthen the belt, unfasten it and
tip the belt tongue at a right angle to the belt.
Pull the belt tongue over your lap until it
reaches the buckle.
If you need to shorten the belt, pull on the loose
end of the webbing until the belt fits snugly.
To unfasten the belt, push the release button on
the buckle. This allows the tongue to unlatch
from the buckle.
R
WARNING
The lap belts should fit snugly and as low
as possible around the hips, not around
the waist.
Safety Belt Extension Assembly
For some people, the safety belt may be too
short even when it is fully extended. You can
add about eight inches (20 cm) to the belt length
with a safety belt extension assembly (part
number 611C22). Safety belt extensions are
available at no cost from your dealer.
Use only extensions manufactured by the same
supplier as the safety belt. Manufacturer
identification is located at the end of the
webbing on the label. Also, use the safety belt
extension only if the safety belt is too short for
you when fully extended. Do not use extension
to change the fit of the shoulder belt across the
torso.
Большое спасибо!
Ваше мнение очень важно для нас.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст