Ford Fiesta (2011 year). Manual — part 112
Anti-corrosion protection
Underbody
E116048
1
2
Description
Item
Underbody PVC stone chip protection
1
Injection points for cavity wax protection
2
G1080183en
501-26-
12
and Tolerance Checks
501-26-
12
DESCRIPTION AND OPERATION
201
Door cavity wax protection
E116049
50 mm
100 mm
All vehicle variants (shown on the 5-door)
G1080183en
501-26-
13
and Tolerance Checks
501-26-
13
DESCRIPTION AND OPERATION
201
Laser weld seams on the front side members
Tailored blank
E116050
1
2
Description
Item
DP600 - 1,4 mm
1
DP600 - 1,6 mm
2
There are laser weld seams on the front side
members. These laser weld seams are used to
join body components of different quality and/or
different material thickness (tailored blanks).
Cut locations exactly on the laser weld seams are
not permitted, as at present no joining techniques
are approved for use in repair procedures that
would re-create joins of the same quality.
Refer to: Front Side Member Section
(501-27 Front
End Sheet Metal Repairs, Removal and
Installation)
(501-27 Front End Sheet Metal Repairs, Removal
and Installation).
G1080183en
501-26-
14
and Tolerance Checks
501-26-
14
DESCRIPTION AND OPERATION
/ Front Side Member and Fender Apron Panel LH
201
Underbody Tolerance Check
1. Body dimensions, all versions (quick
measurements using the Allvis system)
• All dimensions are measured from the middle
of the hole or bolt head or from the edge of
the panel, using the Allvis system, with
component assemblies installed.
• A tolerance of ± 3 mm applies to all
measurements given. All detailed illustrations
correspond to the left-hand side of the
vehicle.
Allvis specifications
Height setting of the test
probes
Adapter
Point of measurement
200 mm
15 mm (Socket)
1
240 mm
25 mm (Probe)
2
70 mm
25 mm (Probe)
3
190 mm
25 mm (Probe)
4
320 mm
25 mm (Probe)
5
320 mm
25 mm (Probe)
6
G1080185en
501-26-
15
and Tolerance Checks
501-26-
15
GENERAL PROCEDURES
201
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст