Chery Tiggo 5 (T21). Manual — part 503
47–
28
47
Front Door Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the front left door trim board garnish.
a. Using a screwdriver wrapped with protective tape, pry
up the claws on front door trim board garnish.
b. Remove the front left door trim board garnish.
4. Remove the front left door trim board assembly.
a. Using a screwdriver wrapped with protective tape, pry
up the clips on front door trim board assembly.
b. Remove the front door trim board assembly.
WARNING
When removing front door assembly, an assistant is needed to hold front door to prevent front door from
dropping to cause accidents during operation.
CAUTION
Be sure to wear safety equipment to prevent accidents when removing front door assembly.
Try to prevent body paint surface from being scratched when removing front door assembly.
RT21470321
RT21470322
47–
29
47
5. Disconnect the front left door connector.
a. Using a screwdriver wrapped with protective tape, pry
up the front door dust boot.
b. Using a screwdriver wrapped with protective tape, pry
up the claws on connector.
c. Disconnect the front left door connector (arrow).
6. Remove the front left door frame weatherstrip.
a. Remove the clip from the front door frame
weatherstrip, and remove the front left door frame
weatherstrip.
7. Remove the front left door buffer block.
a. Using a screwdriver wrapped with protective tape,
remove the front door buffer blocks (arrow).
8. Remove the front left door protector assembly (
9. Remove the front left door assist grip mounting bracket assembly.
RT21470330
RT21470360
RT21470340
47–
30
47
a. Remove 2 fixing screws (arrow) from the front door
assist grip mounting bracket assembly.
(Tightening torque: 1.5 ± 0.5 N·m)
b. Remove the front left door assist grip mounting
bracket assembly.
10.Remove the front left door protective film assembly.
a. Disengage the wire harness clips (arrow).
RT21470350
CAUTION
Avoid damage to front door protective film when removing front door protective film assembly.
Place front door protective film assembly properly after removal, and avoid adhesive sticker on front door
protective film assembly from sticking to other components.
RT21470380
47–
31
47
b. Remove the front left door protective film assembly by
gently pulling it along edges from one corner of the
front left door protective film assembly.
11.Remove the front left woofer assembly. (
12.Remove the left outside rear view mirror assembly (
).
13.Remove the front left door key cylinder protective cover (
).
14.Remove the front left door outside handle.
a. Disconnect the connector (arrow) from the front door
outside handle.
b. Slide and pull the front door outside handle in the
direction of arrow as shown in the illustration, and
remove it.
RT21470370
RT21470390
RT21470381
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст