Chery Tiggo 5 (T21). Manual — part 399
35–
71
35
2. Headlight leveling can be adjusted according to the
number of passengers and loading condition. There are 4
adjustment bands to select on headlight leveling knob: 0,
1, 2 and 3.
Turn up: Rise headlight beam.
Turn down: Lower headlight beam.
Adjust the light according to the table below.
3. Manual headlight leveling: the headlight leveling can be changed by adjusting the following areas manually
as shown in the illustration.
Adjustment method for left headlight
a. Low beam left/right adjustment
When rotating the screwdriver clockwise, the beam
move to left; when rotating the screwdriver
counterclockwise, the beam move to right.
b. Low beam up/down adjustment
When rotating the screwdriver clockwise, the beam
move downward; when you rotating the screwdriver
counterclockwise, the beam move upward.
O
1
2
3
RT21350150
Occupant and Luggage Loading
Condition
Knob Position
Occupant
Luggage
Loading
Driver
None
0
Driver + Front
Passenger
None
0
Full Occupied
None
1
Full Occupied
Full Luggage
Loading
2
Driver
Full Luggage
Loading
3
CAUTION
Whether headlight leveling is correct or not will directly affects driving safety. Be sure to adjust it
according to the related specification.
RT21350160
RT21350170
35–
72
35
c. High beam left/right adjustment
When rotating the screwdriver clockwise, the beam
move to left; when rotating the screwdriver
counterclockwise, the beam move to right.
d. High beam up/down adjustment
When rotating the screwdriver clockwise, the beam
move upward; when rotating the screwdriver
counterclockwise, the beam move downward.
Adjustment method for right headlight
a. Low beam left/right adjustment
When rotating the screwdriver clockwise, the beam
move to left; when rotating the screwdriver
counterclockwise, the beam move to right.
b. Low beam up/down adjustment
When rotating the screwdriver clockwise, the beam
move downward; when you rotating the screwdriver
counterclockwise, the beam move upward.
RT21350180
RT21350190
RT21350200
RT21350210
35–
73
35
c. High beam left/right adjustment
When rotating the screwdriver clockwise, the beam
move to left; when rotating the screwdriver
counterclockwise, the beam move to right.
d. High beam up/down adjustment
When rotating the screwdriver clockwise, the beam
move upward; when rotating the screwdriver
counterclockwise, the beam move downward.
RT21350220
RT21350230
35–
74
35
Rear Combination Light Assembly (Fixed Part)
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for rear left combination light.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the rear combination light assembly (fixed part).
a. Using a flat tip screwdriver wrapped with protective
tape, pry up and remove the rear combination light
service cover.
b. Disconnect the rear combination light assembly (fixed
part) wire harness connector (arrow), and detach the
wire harness fixing clip.
c. Remove 2 fixing screws (arrow) from outer part of rear
combination light assembly (fixed part).
(Tightening torque: 1.5 ± 0.5 N·m)
RT21490153
RT21350240
RT21350250
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст