Chery Tiggo 5 (T21). Manual — part 480
44–
12
44
Rear View Mirror Adjustment Switch Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the rear view mirror adjustment switch
assembly.
a. Using a screwdriver wrapped with protective tape, pry
out the headlight adjustment switch unit panel.
b. Disconnect the rear view mirror adjustment switch
connector (arrow).
c. Using a screwdriver wrapped with protective tape,
detach the claws (arrow) of rear view mirror
adjustment switch assembly.
d. Remove the rear view mirror adjustment switch assembly.
CAUTION
Make sure to wear safety equipment to prevent accidents when removing rear view mirror adjustment
switch assembly.
Prevent instrument panel lower left protector assembly from being scratched when removing rear view
mirror adjustment switch assembly.
RT21440120
RT21440130
RT21440140
44–
13
44
Inspection
Check the outside rear view mirror adjustment switch
assembly.
a. Adjust the rear view mirror adjustment switch
assembly to "L" position.
b. Using a multimeter, check for continuity between
terminals of rear view mirror adjustment switch
assembly according to the table below.
If result is not as specified, replace rear view mirror
adjustment switch assembly.
c. Adjust the rear view mirror adjustment switch
assembly to "R" position.
d. Using a multimeter, check for continuity between
terminals of rear view mirror adjustment switch
assembly according to the table below.
If result is not as specified, replace rear view mirror
adjustment switch assembly.
L
R
1 2
3 4 5
6 7
8 9 10
-
+
RT21440150
Multimeter
Connection
Switch
Condition
Specified
Condition
Terminal 3 - 7
Terminal 4 - 5
UP
Continuity
OFF
No continuity
Terminal 3 - 5
Terminal 4 - 7
DOWN
Continuity
OFF
No continuity
Terminal 3 - 6
Terminal 4 - 5
LEFT
Continuity
OFF
No continuity
Terminal 3 - 5
Terminal 4 - 6
RIGHT
Continuity
OFF
No continuity
L
R
1 2
3 4 5
6 7
8 9 10
-
+
RT21440150
Multimeter
Connection
Switch
Condition
Specified
Condition
Terminal 3 - 8
Terminal 4 - 5
UP
Continuity
OFF
No continuity
Terminal 3 - 5
Terminal 4 - 8
DOWN
Continuity
OFF
No continuity
Terminal 3 - 9
Terminal 4 - 5
LEFT
Continuity
OFF
No continuity
Terminal 3 - 5
Terminal 4 - 9
RIGHT
Continuity
OFF
No continuity
44–
14
44
Installation
Installation is in the reverse order of removal.
CAUTION
Always operate carefully to prevent components from being damaged when installing the rear view
mirror adjustment switch assembly.
Install each connector in place when installing rear view mirror adjustment switch assembly.
Check that switch can operate normally after installing rear view mirror adjustment switch assembly.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст