Chery Tiggo 5 (T21). Manual — part 479
44–
8
44
Inspection
1. Inspect the left outside rear view mirror assembly.
a. Apply battery voltage to the terminals of outside rear
view mirror assembly connector and check the
operation of outside rear view mirror according to the
table below.
If result is not as specified, replace the left outside rear view mirror assembly.
Installation
Installation is in the reverse order of removal.
1
2
3
8
9
10 11 12 13 14 15 16
4
5
6
7
-
+
RT21440040
Measurement Condition
Specified
Condition
Battery positive (+) → Terminal 3
Battery negative (-) → Terminal 2
UP
Battery positive (+) → Terminal 2
Battery negative (-) → Terminal 3
DOWN
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
LEFT
Battery positive (+) → Terminal 2
Battery negative (-) → Terminal 1
RIGHT
CAUTION
When installing outside rear view mirror assembly, install connector in place and tighten fixing bolts to the
specified torque.
Make sure outside rear view mirror assembly can move smoothly after installation.
44–
9
44
Outside Rear View Mirror Housing Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the left outside rear view mirror housing
assembly.
a. Using a screwdriver wrapped with protective tape,
remove the clip from outside rear view mirror housing
assembly, and remove the left outside rear view mirror
housing assembly.
Installation
Installation is in the reverse order of removal.
CAUTION
Avoid breaking the claw when removing outside rear view mirror housing assembly.
Avoid damaging lens due to dropping when removing outside rear view mirror housing assembly.
Try to prevent body paint surface from being scratched when removing outside rear view mirror housing
assembly.
RT21440050
CAUTION
Make sure to install outside rear view mirror housing assembly in place.
44–
10
44
Outside Rear View Mirror Lens Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the left outside rear view mirror lens assembly.
a. Press the outside rear view mirror surface to tilt it.
b. Apply protective tape around the outside rear view
mirror frame.
c. Using a screwdriver wrapped with protective tape, pry
up the claws (arrow) of outside rear view mirror lens
assembly.
d. Remove the left outside rear view mirror lens assembly.
Installation
Installation is in the reverse order of removal.
CAUTION
Avoid breaking the claws when removing outside rear view mirror lens assembly.
Avoid damaging lens due to dropping when removing outside rear view mirror lens assembly.
Try to prevent body paint surface from being scratched when removing outside rear view mirror lens
assembly.
RT21440090
CAUTION
Make sure the lens can move smoothly after installing outside rear view mirror lens assembly.
44–
11
44
Inside Rear View Mirror Assembly
Removal
1. Remove the inside rear view mirror assembly.
a. Remove the fixing screw from inside rear view mirror.
(Tightening torque: 1.5 ± 0.5 N·m)
b. Remove the inside rear view mirror assembly in the
direction of arrow as shown in the illustration.
Installation
Installation is in the reverse order of removal.
CAUTION
Appropriate force should be applied when removing inside rear view mirror assembly, and operate
carefully.
Avoid scratching front windshield assembly when removing inside rear view mirror assembly.
RT21440100
RT21440110
CAUTION
Make sure the inside rear view mirror assembly can move smoothly after installation.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст