Chery Tiggo 5 (T21). Manual — part 243
20–
9
20
b. Remove the inner ball cage in the direction of arrow,
and place it on a piece of clean cloth.
4. Remove the tripod.
a. Using snap spring calipers, remove the positioning
snap spring of tripod.
b. Put matchmarks on the tripod and drive shaft, and
remove the tripod.
5. Remove the dust boot.
a. Wrap tape on the spline of drive shaft, and remove the
dust boot.
Inspection
1. Check if spline of drive shaft is in good condition. If it is deformed or damaged, replace it.
2. Check if dust boot is in good condition. If it is scratched or broken, replace it.
3. Check if positioning snap spring of tripod is deformed. If it is deformed, replace it.
RT21200050
RT21200060
Matchmark
RT21200070
7DSH
RT21200080
20–
10
20
Assembly
Assembly is in the reverse order of disassembly.
CAUTION
Refill grease during assembly.
Operate carefully to prevent the dust boot from being damaged.
20–
11
20
Outer Ball Cage
Disassembly
HINT:
Use the same disassembly and assembly procedures for left and right drive shaft assemblies.
1. Remove the drive shaft assembly (
2. Remove the outer ball cage dust boot outer clamp.
a. Using a screwdriver, pry out the striker of outer ball
cage dust boot outer clamp and remove the outer ball
cage dust boot outer clamp.
3. Remove the outer ball cage dust boot inner clamp.
a. Using a screwdriver, pry out the striker of outer ball
cage dust boot inner clamp and remove the outer ball
cage dust boot inner clamp.
4. Remove the outer ball cage.
a. Slide the outer dust boot (1) carefully into the inner
ball cage side in the direction of arrow.
b. Put a matchmark (1) on the area with the same height
as drive shaft assembly (2) and edge of outer ball
cage (3) for correct installation.
RT21200090
RT21200100
1
RT21200110
2
3
1
RT21200120
20–
12
20
c. Wrap the drive shaft assembly with a piece of cloth
and put it onto a vise. Secure the vise to prevent the
drive shaft assembly from shaking. Tap the outer ball
cage (1) forcibly with a hammer, and remove the outer
ball cage (1).
5. Remove the retaining ring (1).
6. Remove the outer ball cage dust boot.
a. Wrap tape on the spline of drive shaft, and remove the
dust boot.
b. Remove the tape.
Inspection
1. Check if spline of drive shaft is in good condition. If it is deformed or damaged, replace it.
2. Check if dust boot is in good condition. If it is scratched or broken, replace it.
Assembly
Assembly is in the reverse order of disassembly.
1
RT21200130
1
RT21200140
7DSH
RT21200150
CAUTION
Refill grease during assembly.
Install it with new clamps.
Operate carefully to prevent the dust boot from being damaged.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст